KCG200WH1 model When disassembled, small, silver, pebbled inside washer fell out from unit. Can't see where it fits. If for toggle switch, doesn't seem to be enough room.

Hi
We wouldn't advise a Pebble fabric on a Mico as the models are a different design so the Pebble fabric wouldn't be an optimum fit on the Mico model.
For replacement Mico fabric contact [email protected]

just bring your casio watch to casio service center, i'm sure they have what you are lookin for.

I believe their is another part missing when it fell apart. But it is better if you replace it with a new one.

In most units, there is a 'splash shield' that is held in place by friction only that can be easily removed. This creates the extra space (for my hand at least) to reach down into the unit to clear any hard objects. If you have pebbles in the basket of the unit, you should be able to remove them by hand without further disassembly. If you find nothing to remove, then the noise comes from elsewhere (bearing, blades) since anything that has managed to get out of the basket, won't make noise any more.

pump and motor assm,bad

Top lid pull up. Look in seam between top and front cover. On each side you will see where top clips to front cover. Put a screwdriver in there and lightly pry up till clip releases. Front cover will now pull up and be removed, so you could get what fell in.

2 bolts hold the entire igniter/burner valve tray in place. Remove the entire tray for convenient access. Go to the link I am providing you to choose your model, when you do, it will give you the manuals, open the one for your model and it comes apart the same way it was put together, just backwards. http://www.weber.com/support/manuals/?id=2

When you are looking at the drawer, the magnet stands upright on the far right side just inside the outer front casing about halfway down. There is a small plastic clip that holds it in place. You don't need to take anything apart to reinsert the magnet, just open the drawer, but it may be easier to see the location if you pull the drawer all the way out of the hole.

cheapest way is to go into appliance shops and look at other washers that are similar. note how theirs is assembled.