Install ge profile p/n WB27T11042 touch pad - GE Profile PGS968SEPSS 30" Slide-In Gas Ranwith 4 Sealed Burners, 4.1 cu. ft. Two Speed Convection Oven, Self Clean, PowerBoil Burner, 3 Heavy Duty Oven Racks, StoraDrawer and ADA Compliant: Stainless Steel

You didn't give a model number, but try the following:

For an electronic clock:
Touch the Clock pad. Touch the number pad. Touch the start pad until the time of day shows in the display. (Taken from the GE website)

It is more than likely the touch pad is bad. It could be the electronic control or worst case both. Touch pads are notorious for giong bad. i would look there irst.

The touch pad is more than like the problem. This is common. Try removing the ribbon connector and reinserting it back in the receptacle. If this doesn't fix the problem then replace the touch pad.

Seems problem with the touch pad. Try replacing the same.

Problem seems most likely damage or corroded touch pad connections inside or outside and this is common problem for most touch pads as moisture and humidity enters inside touch pad mechanism and problem can be solved with replacement of needed parts and most likely touch pad must be replaced

F 11 code. it is a touch pad error.
If you just cleaned the control panel it may have water in the panel causing a key to stick.
If after a day or 2 it hasn't dried out - then you will need to replace the touch pad.

Visit www.searspartsdirect.com and enter in your full model number for a parts breakdown and schematics.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

eith touch pad or control board un plug the touch pad if it returns the board is bad if it dont the touch pad is

Sadly, GE does not make individual parts available for these controllers, so they cannot be repaired.

You have to replace the control panel sub-assembly (part number WB07X10733 in your case) and the best price I've found on that is $370.32 here (compared to $483.25 direct from GE).

In my opinion, this does not do much to inspire brand loyalty...

Or you may be able to find a whole oven on eBay for about that or less.

Sorry to bear bad news. Good luck.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer

This is your electronic control board that needs to be repalced on this unit. GE Profile is a great brand and it is easy to repair, also.

We provide part removal/installation instructions for our customers when you purchase your parts from us.We also ship parts overnight to assure that you get your oven repaired right away.

Please contact us at:
http://www.fixya.com/repair/d499389-accurate_appliance_repair_service
from 7 AM until 9 PM CST. We look forward to getting you cooking again soon.

Thanks, Ella

replace the control board