No string id 2212 - OTC Spx Corporation/otc Genisys MultiTech 56K PCMCIA Modem Kit

Software TK-2212 is KPG-100 and normal kenwood cable KPG-22 can be used for programming.

I believe so. You will need to know the construction of the caller ID string sent by the telco through PRI and then the ICS needs to be programmed to display the portion(s) of the string desired by the customer.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/dave_fb2c45146b845cea

ok. Never pull fabric, it will bend the needle and cause you even more problem. So stop doing that.

Look in your manual for where the feed dog switch is. It might be under the "darning" area.

Good luck

check that the end fences are up against the paper in all the trays.

In your machine (model) you have to enter in SP mode to reset your error code.
Try this:
Yellow key.
1-0-7 on the key pad
Red key at least 3 sec.
Press "copy sp"
On the key pad press 5 810 and #.
Press execute
Exit all the way out.
Turn the machine off and on.

what is your error code

If you haven't actually manually changed it, the password is always the last four digits of your phone number (ex. 1-555-868-2212 your password is 2212). If you manually changed it, you need to call Verizon and have that worked out.

-CompDoctor

If you haven't actually manually changed it, the password is always the last four digits of your phone number (ex. 1-555-868-2212 your password is 2212). If you manually changed it, you need to call Verizon and have that worked out.

-CompDoctor

dod't afraid contact me [email protected]

Go to; Gestetnerusa.com -- click on the 'support & drivers' tab --- insert/ select your machine -- then select your OS (operating system) and dowload.