Question about K and N Kawasaki Kfx450 Kfx450r K and n Air Filter Kfx 450 2008

1 Answer

Kawasaki 450r I have a 2007 Kawasaki 450r. It was running fine then After about 30 minutes it would stall no matter how much throttle was given when The clutch was released all the way. It would idle fine,, but progressively got to where it would stall after idling in neutral also. Brought it home and let it cool down. Tried to start it 30 minutes later and now will not even attempt to turn over. I've used the choke and let the engine warm up properly prior to riding. Just went to turn around and it just started stalling all of a sudden when clutch was fully released. Any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

I had a similar problem on one of my bikes. Turned out a "Test Port" had rattled loose between the carb and the intake. I threaded a screw in the hole to prevent the leak and problem was resolved.

Posted on Jul 09, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kawasaki 17 hp stalls when hot


you need valve job done and new valves put in and i said new valves do not use old valves again 150.00 per cylinder

Sep 07, 2014 | John Deere Garden

1 Answer

Starts stalls


contaminated or water in the fuel is most likely the culprit here.
drain the tank and carb (small screw at bottom of carb float bowl)
Add fresh fuel from a CLEAN fuel source. Best to completely drain your fuel can and fill it up with fresh fuel. That way if the fuel can is the culprit you eliminated doing this twice.
What happened was fuel sits on top of water, this is why the bike would still idle. The idle circuit in the carb pulls fuel from a higher point than the main jet. This is also why when you hit the throttle it would just die, it was sucking most like something other than fuel.

Apr 02, 2014 | kawasaki KX 450 F Motorcycles

1 Answer

1999 eclipse manual trans.2.0 engine non-turbo kills when stopping


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 19, 2012 | 1999 Mitsubishi Eclipse

1 Answer

2002 Kawasaki VN 1500 Vulcan dies when put into gear


Hi, Kdompe357 and the usual suspects are:
1. Faulty wiring to any safety switch.
2. Safety switches loose at the mounting point.
3. Faulty kickstand safety switch.
4. Failed kickstand safety switch circuit diode.
5. Stretched side stand spring.
6. Side stand not coming up far enough to disengage switch.
7. Faulty clutch lever safety switch.
8. Faulty neutral safety switch.
9. Clutch not properly adjusted.
10. Clutch plates sticking, forward lurch
For more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Vulcan 800 Classic Stalls When Shifting Into 1st
Stalls when putting into gear first time
Suzuki VL1500 Service Manual
OEM parts for Suzuki
Suzuki Intruder VL1500B Owner Manual

Jun 24, 2017 | 2002 kawasaki VN 1500 Vulcan Meanstreak

1 Answer

Rode for 120 kilometers pulled over and filled gas tank soon after smiled gas. Seemed to run fine. Next day rode for about 50 km but sounded really rough at high speeds around 120km. Pulled over to park in...


I would suspect that the float is sticking. Checking will require removal of (in order): seat, tank, air filter box/backing plate, and finally, the float bowl at the bottom of the carb. Insure that the float is not flooded, and that the float needle is free of trash.

Aug 30, 2010 | 1996 kawasaki VN 800 Vulcan Classic

1 Answer

Bike stalls if moved


check carb for bent needel or any other damage

Oct 10, 2009 | 2004 Vento Rebellian

Not finding what you are looking for?
K and N Kawasaki Kfx450 Kfx450r K and n Air Filter Kfx 450 2008 Logo

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top K and N Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

ray gallant

Level 3 Expert

42930 Answers

Are you a K and N Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...