Question about Whirlpool Ultimate Care II LSQ9549L Top Load Washer

1 Answer

Fabric softener leaking from bottom of washing machine

I have a pool of fabric softener under my washing machine. What could the problem be?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

One possible cause.
Someone is pouring fabric softener in the washer's Bleach bezel.
Causing the bezel to become clogged and then overflow.

Posted on Apr 04, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: fabric softener leaks out at beginning of wash

I have a 9200SQ Whirlpool duet.  It might be similar.  I think the bleach and fabric dispensers work on the siphon principal--once the level gets above a certain point they will then siphon out until almost nothing is left.  They should not start to siphon until extra water is directed into them during the correct cycle.   It is possible that they are starting to siphon early because 1. the washer is not level, 2. water is being added to the dispenser during the wrong cycle 3.  You put too much liquid into the dispenser and it started the siphon. 
Note:  You should not peek in the dispenser during the washer cycles because it might interrupt the "siphon"action and leave residual bleach or fabric softener in the dispensers.

Posted on Oct 31, 2007

vest6
  • 196 Answers

SOURCE: Whirlpool Imperial

With the machine off and empty, fill the softner bin with water only. Does the water level go down or stay the same.

Posted on Jan 02, 2008

  • 6 Answers

SOURCE: fabric softener dispencer

The inlet for the softener may be plugged. Try a toothbrush to clean the area.

Posted on Jan 14, 2008

  • 1073 Answers

SOURCE: Machine will not use fabric softener

the despenser has a servo motor on the top of the despenser, you have to remove the top of the washer to get to it, it is on the left side of the unit looking form the forunt, check the motor woth a vom meert on resistance, if you get a reading, meter needle moving twards the right the motor probally is good, if no eter movement the the motor is bad
if you have meter movement after checking the motor then the control board is bad

Posted on Apr 10, 2008

  • 1 Answer

SOURCE: fabric softener dispensing before wash begins

I was having the same problem. Repair man replaced VALVE AW
He told me it is from the sedement in your water. If you have a water softner, it may not be the problem, unless it is not working properly. Sounds strange, but problem is fixed.

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fabric dispenser leaves water in dispenser after wash is done


Fabric Softener Compartment Full Of Water - White Goods ...

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help
Jul 9, 2013 - The small fabric conditioner compartment in the soap dispenser drawer has a ... filter at the bottom of my machine is also full of water after every wash my machine is Russell ... My washer flushes out the softener but then leaves the water at the end. ... When the wash cycle has finished the fabric conditioner ...

Jan 16, 2016 | Washing Machines

1 Answer

Iwd71250uk fabric softener staying in dispenser.


Compartment 3: Additives (fabric softeners, etc.)
The fabric softener should not overflow the grid.
25825864-ineink0kisfnom0atbkujjcx-3-0.jpg

Cleaning the detergent dispenser drawer
Remove the dispenser by raising it and pulling it out (see figure below). Wash it under running water; this operation should be
repeated frequently.

25825864-ineink0kisfnom0atbkujjcx-3-10.jpg 25825864-ineink0kisfnom0atbkujjcx-3-3.jpg 25825864-ineink0kisfnom0atbkujjcx-3-6.jpg
Dado

Aug 17, 2015 | Indesit Washing Machines

1 Answer

How do I get the fabric softener dispenser to keep from filling with water?


Remove dispenser and clean the drain hole from under neath try with q tip.sounds gunked up.

Sep 01, 2014 | Frigidaire Affinity ATF6000F Front Load...

1 Answer

My washer cannot wash off liquid fabric softener so good. Some softener sticks into the clothes. Guess the the bottom of dispenser needs cleaning or maybe theres a lot of fabric softener left under it. How...


Hope this helps.You need to remove the washer to see whether debris blocked drain hoses.there might be clothes metal that blockes the drain hose..Hope this helps.

Jun 19, 2011 | Maytag PAV2300 Top Load Washer

1 Answer

Lint on cloths after wash is there a lint filter in the washer and where do i find the lint filter


There is a fine screen on the bottom of the inner tub under the agitator. It is self cleaning every time it spins out. If you use too much fabric softener, the screen can get clogged. Fabric softener is hard to clean off and the screen is pretty delicate.

Jan 03, 2010 | Whirlpool LSR7333 Top Load Washer

2 Answers

Bosch nexxt washer fabric softener not draining


is there a drain on the bottom left corner if so drain the contents its usually under a small panel

Sep 14, 2009 | Bosch Nexxt 500 WFMC3301 Front Load Washer

1 Answer

GE washing machine leaks at bottom


If this machine has a place to put pour fabric softener in that's sits under the lid on the cabinet? If so, the hose that allows the softener drain into the tub is either leaking or is disconnected.
Please rate this solution if helpful

Aug 20, 2009 | GE Washing Machines

1 Answer

Fabric softener is left in bottom of drum after wash cycle completes


We had the same problem. You have to remove the part that the softener goes in and clean it. You will be amazed at how much build up is in there. That solved the problem for us.

Jun 18, 2008 | Maytag SAV5710 Top Load Washer

1 Answer

Fabric softener dispencer


The inlet for the softener may be plugged. Try a toothbrush to clean the area.

Jan 09, 2008 | Whirlpool Duet GHW9150P Front Load Washer

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9549L Top Load Washer Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Sal DeAngelo

Level 3 Expert

2122 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...