Display colors on monitor

If all software setting done perfectly but till color problem in your monitor, then need to call monitor technician. It may occur from crt neck base loose contact or bad contact. need to replace new one.

normally no need to discharge crt capacitor for repairing dry soldering.

model number of the camera please

Robert

What your describing is a major video problem, poor color and it is blurr, It would be far cheaper to replace the monitor with a new one.

problem with the monitor Display cable. it is damaged.

Normally monitor will receive 3 colors red, green, Blue signals from CPU. If one cable i.e Red wire connection is missing in display cable which is connected to monitor, Red color image on monitor wil be replaced with other fade color.
So, need the replace the display cable or display connector!

check the signal cable bend it in on condition and look what difference in color occurs if so then replace the cable if not that fault then ther is a dry solder on the base of monitor find out and clear it

my sharp tv was like that to but our tv color was blue with also gray horizontal lines i did cheack all d caps resis... etc dont know what to do LoL.

Any of the 3 internal wires that delivers the tree color (Reg-Grenn-Blue) is disconected or damaged.

Open your monitor and try to locate that wires...

Good Luck

Best Regards !

try to check ur Picture tube 

Try looking at the LCD screen at a sharp angle to see if ghost-like video can be seen during the 'off' time of the flicker.  If video is still present even though not that visible, then either the backlight or its power supply are failing. The color problem could also be caused by a backlight lamp that is not ionizing completely.

Your monitor is missing blue drive. Most likely a component failure on the CRT board. Bad color ICs, bad solder connections or defective capacitors can cause the problem.