Question about EliteGroup Computers & Internet

Open Question

HOW TO CHECK ECS MOTHERBOARD WARRANTY (EA-1078D22A27P5)

WORKING NOT CORRECTLY

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ecs motherboard warranty service in kerala


Check With good RAM as Motherboard supported RAM type. Use a graphics card to check where your built in VGA is bad or not. Another stupid thing is please check your Monitor. some times it makes everyone fool.

Jul 08, 2013 | Computers & Internet

1 Answer

A740GM-M- DOES THE SERIAL NUMBER START WITH EA OR WITH V


For motherboard without parallel port: please check the farthest PCI slot from the center of the board, which is also the closest to the edge of the board. A white sticker with motherboard serial number is attached to the PCI slot.
It includes one letter +five numbers + one letter + eight numbers as follows.

http://www.ecs.com.tw/extra/productinfo/MB.htm

Jan 16, 2011 | EliteGroup ECS A740GM-M Value Socket...

1 Answer

Ok, so my computer is a home build system with the EliteGroup ECS 945GCT-M/1333 Motherboard - v3.0. i was using windows xp for a long time and every thing worked correctly but i recantly upgraded to...


control panel admistrive tools,computer management,device manager scroll down sound and video controllers you should see a yellow question mark? right click to reinstall drivers you might find something there hope this helps

Sep 15, 2010 | EliteGroup ECS 945GCT-M/1333 Motherboard -...

1 Answer

ECS MOTHERBOARD NO BOOTING UP


They must have correct ram installed.

Hard to believe all 10 are faulty.....sounds like a ram fault.

Could also be wrong / faulty CPU

Apr 12, 2010 | EliteGroup ECS P4M800-M7(3.1) LGA775 ALL...

2 Answers

Cannot find the SATA hard drives for my ecs 915PL-A2 mother board. All connections have been checked


Did it just stop? Or is the a new system?
Did you check your BIOS settings?
ECS is not known for excellent quality - if you have a bad board hopefully it is still under warranty.

Mar 04, 2010 | EliteGroup (ECS 915PL-A2) Motherboard

1 Answer

Sound Only through Headphones -ECS A770M-A


Start button>settings>control panel>sounds and audio devices>

Middle tab [audio]
default device, hit the down arrow
and choose the other device


I keep a shortcut on quicklaunch because I switch them all the time.

Jan 09, 2010 | EliteGroup MB ECS A770M-A 770 SB600 AM2+...

2 Answers

P4Vmm2 Manual


http://www.ecs.com.tw/ECSWebSite/Downloads/ProductsDetail_Download.aspx?detailid=277&DetailName=New&DetailDesc=&CategoryID=1&MenuID=6&LanID=0

All you need is in the link above:

please leave a rating ...

May 16, 2009 | EliteGroup P4VMM2 Motherboard

1 Answer

ECS 755 A2 motherboard problems


Make sure you have the correct front panel header connected correctly to the case wires. Open you're manual to page 12 under the English section. There you'll find a picture of the front panel header & how to connect the case's LED's to the motherboard.
If you no longer have the manual you can download it from ECS at this link.
http://www.ecs.com.tw/ECSWebSite/Products/ProductsDetail.aspx?detailid=381&DetailName=Manual&MenuID=1&LanID=0
Chances are you may have the wire's connect backwards. (Positive + connected to the negative - ECT).
Example, pin 1 is the + for hard disk drive & pin 3 is - for the hard disk drive. Cases vary on wire colors, normally if each connector has a common colored wire (solid color) that common wire would be the negative. Stripped wires are negative. Other cases use white colored wires as negative & colored wires as positive. As far as you not receiving any display. Try removing the AGP card & clean the copper contacts. Clean with alcohol.
Place a couple drops onto a cotton swab & clean the copper, both sides. Blow out the AGP slot with canned air. Re-check all connections, power & data cables before closing the case. Power on the system & check the front led's for operation.
If you still fail to get display, re-check the connection from the monitor to the case. Try you're monitor on another system. If good than you're video card could be bad. You're motherboard can run an 8x/4x speed AGP 1.5volt (only) graphics card.

Good luck zeratu_l !
Need more help? Post within this link.

Mike

Jul 28, 2008 | Computers & Internet

1 Answer

New ECS 915G-M Motherboard Problem


Hi, first check if you have a red or green ready led light on somewhere on the mobo. then check if you have the cables from the front of the case attached to the correct pins on the board. your board documentation will tell you which pins and the case cables are marked as to which ones they are. regards mistyman

Oct 05, 2007 | EliteGroup 915G-M Motherboard

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top EliteGroup Computers & Internet Experts

David
David

Level 3 Expert

778 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1066 Answers

Jerry Umali

Level 3 Expert

979 Answers

Are you an EliteGroup Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...