Question about Chevrolet Vehicle Parts & Accessories

1 Answer

Shuts off while driving and looses all lights

Motor shuts down and all lights and

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,051 Answers

Sounds like the alternator is not putting out. If you start the car and remove the battery cable and the engine shuts off then the alternator is bad and you need to change it.

Posted on Oct 04, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Got 87 Chevy 4x4 350 TBI at ideal it rev up and down when driving down road its like you turn key off but picks back up for a second then stalls again the motor has 3,200 miles replaced dang near...


Sounds like multiple problems. rev up and down at idle sounds like vacuum leak. shutting down while driving sounds like loose wire in the ignition system or possibly in the fuel pump.

Jan 30, 2015 | Cars & Trucks

1 Answer

Motor wont run. elevation and console works.


1) the lack of LUBE is the problem, you must do it every 5 hours aprox by use. The system shut down for to protect itself in the electronic component. Maybe you have a WORN deck belt,, time to replace.
2) LUBE the rollers bearing TOO v. important
3) test the drive belt for loose and test the ball bearings motor and replace it if necessary.
God bless you

Nov 18, 2012 | Horizon T92 - Treadmill

1 Answer

Does not complete the wash cycles. Has code of F6


The "F06" error code is indicating a Drive Motor Tachometer Error. The control is unable to properly detect motor speed and the washer will shut down. If a failure occurs during high speed spin the door will be unlocked after 3 minutes.

Potential Causes:

Loose wire connections between the Drive Motor and the Motor Control Unit (MCU), and between the MCU and the Central Control Unit (CCU). Drive Motor MCU Wire harness I recommend calling a service technician to diagnose and repair your washer.

Jul 15, 2011 | Whirlpool Washing Machines

1 Answer

I just replaced the Starter,Fuel pump and selinoide under the battery. Dropped the tank and cleaned it and my 1988 jeep 4.2 litre still stalls/cuts out on me when I am either driving or slowing down at a...


if it acts like you turned the key off where the motor just shuts off without missing and sputturing i would for sure look at changing crankshaft sensor or may be a camshaft sensor if it has one. once sensor looses track of timing computer will shut down motor.

Dec 22, 2010 | 1988 Jeep Wrangler

1 Answer

Over heating , no water in oil , no oil in water


fan clutch could be bad if it doesnt have electric fans. thermostat could be stuck shut. water pump may be bad s the impeller inside can come loose from the shaft the belt drives. dont drive until fixed as any new motor noise is sign of potential internal motor damage and may lead to engine failure.

Jun 04, 2010 | 2003 Mitsubishi Outlander

1 Answer

Engine motor mounts / electrical harness


Yes if the mount is not on the correct way it will cause problems like that and even kill the motor while driving down the road. When the van was made thay put one of the main wiring harness's under the motor mount that bolts to the block. When its comes loose or off it starts shorting out your motor. You will ether need to replace the bracket or bolts or both. Bolt size is a M10 1.5 its a 17mm head. Or they might be loose. Mount is located in the front of the van inbetween the motor and transmission. Hopes this helps

Jan 11, 2010 | 1995 Dodge Caravan

2 Answers

Van shuts off when I slow down at lights


Sounds like your serpentine belt driving the alternator and power steering units is too loose. If you haven't had it replaced, it may be time.

Sep 20, 2009 | 1996 Chevrolet Astro

1 Answer

2004 Navigator engine shuts off while in drive or reverse


crude in the catlic convertor will cause this problem when hitting the bump in the road u are jarring it loose should have exhaust system check out

Nov 16, 2008 | 2004 Lincoln Navigator

Not finding what you are looking for?
Vehicle Parts & Accessories Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Vehicle Parts & Accessories Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Mike

Level 3 Expert

4340 Answers

Are you a Chevrolet Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...