Preset stations jvc ux-t3

Question edited for full 'make model (what it is)'.
Question moved to a JVC category.

Videos that may help.

https://www.google.com/search?q=jvc+ux+d457s+no+display

..

You can only preset stations one by one. First, you can do a full scan for all stations in range. Press and hold the Stop button on the unit. Press Play/Pause to start the scan. (There are alternate methods using the remote control. See page 17 of the manual.) Press Fast Forward or Fast Reverse on the unit to navigate through the stations that have signal.

To set a preset, tune in a station using the Tune+/Tune- buttons on the remote or Fast Forward/Fast Reverse. Then press and hold Prog/Preset on the remote. When you see ##Empty or a preset number, use Tune+/Tune- to select one of the 20 preset storage numbers. Press OK/Play/Pause to save the preset. (If using the buttons on the unit, press Fast Forward/Fast Reverse to select a preset location. Press Play/Pause to save. You will see Stored on the display in either case, if you successfully saved the frequency to the location.

ManualsLib has the manual for the JVC UX-S327B here: https://www.manualslib.com/manual/1939546/Jvc-Ux-D327b.html#product-UX-D327B . See page 18 for presetting stations.

I hope this helps.

Cindy Wells

Yes on the rear of the unit

My brother took the case off my JVC system and the ground wire was off. He fixed that and everything works just fine YAAAY!

1. Tune to the station you want to set the preset to.
2. Short-press the "menu" button.
3. Using dial, select the preset you want to set it to.
4. Long-press the dial to store the preset.

Click HERE to download user manual of JVC UX-N1
Thanks.

To set individual presets: 1. tune to the station you want as a preset 2. hold down the number (ie "1") on the remote until the number blinks on the system 3. repeat for all other stations
press the number on the remote to tune to your preset
this is very similar to setting the presets on my car radio

I found the user manual but they want $4.95
http://www.s100-manuals.com/manualdetails.asp?id=306283

tune into the station you want as normal. Then on the remote, press & hold the number key for the preset number you want. This will flash in the display to show you it's set. You can preset 30 FM & 15 AM stations.

The radio was improperly installed; there are two 12V leads, one services the radio when on, the other, only the circuitry for the clock and presets.
Eventually, this shouldn't be needed if the manufacturers ever think about using a little bit of flash memory for the presets and a coin cell for the clock.

You didn't give any model number so researching the manual is impossible.
If you can find the model number, look for a user's (or installation) guide on line to find the wiring info.