Coby csmp95 manual

It is not recommended to change the bolt pattern on a Raptor 660. The bolts are designed to fit the frame and any alterations could weaken the frame and cause damage. If you are looking to change the bolt pattern, you should consult a professional mechanic or experienced fabricator who is familiar with the Raptor 660.

go to setting I think security or there should a pattern lock setting go there should say change password setting it will ask to type old 1 in and then type a new passcode in

If you cant find one, take a piece of paper with a drawing pencil an rub pencil over back of paper laid on unit. Carpenters do it all the time to get a replica of something they need it will fill the holes an make a pattern you can cut out an be close enough.

try this:
http://geek4biz.blogspot.com/2014/01/unlock-mitraveler-or-other-tablets.html

coby kyros mid:7036
how can i unlock my pattern

you must claim this to the company where do you buy it. Can be the control be defective. Go and return it for fix it or exchange it.

God bless you

my button on my coby soundbar does not work only standby button

the mounting bring the right screws for every sides

theyre should be a plactic cover inside the car in line with the mirror there should be too 2 bolts holding it on

The following is verbatum from the mitsu engine overhaul manual... Steps 7 and 8 are a bit cryptic, but it seems like after you tighten the bolts to 20nm in the CORRECT PATTERN... you then go around tightening 1/4 turn through the pattern, then a final 1/4 turn through the pattern... do NOT tighten each bolt to 20, the 1/4 then another 1/4 before going to the next bolt, the idea is to get EVEN tightening across the head, so tighten her three times around the pattern! Now for the verbiage from Mitsu's overhaul manual...


(1) When installing the cylinder head bolts, check that the
shank length of each bolt meets the limit. If the limit is
exceeded, replace the bolt. - Limit: Max. 96.4 mm (3.79 in.)
(2) Install the washers.
(3) Apply engine oil to the bolt threads and washers.
(4) According to the tightening sequence, tighten the bolts to
75 Nm (54 ft.lbs.).
(5) Loosen the bolts completely.
(6) Torque the bolts to 20 Nm (14.5 -ft.lbs.)
(7) Tighten the bolts l/4 turns (90”) more.
(8) Tighten the bolts l/4 turns (90”) additionally.