Question about Audio Players & Recorders

1 Answer

I have low RF signal from my sennheiser ew 300 g3 during church service when the pastor speaks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Have you run an RF scan in the building you're using the in-ear monitors to see what the spectrum looks like? Shure has a nice tool on their website to do that. Once you identify the available frequencies, try changing the transmitter & receiver to one of these new frequencies and I'm sure you're problem will be solved. That IF indeed this is an RF problem.

Posted on Apr 02, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 31 Answers

SOURCE: Popping over the house speakers.

Has it always done this or recently started?
Try to determine if the popping is coming from the words spoken into it, or if you get popping from simply moving the mic and cable around. if you get popping from simple movement, there is a chance that the mic needs to be replaced. We use these in our church, and over the last 6 years I've had to replace about 6 of them...sometimes they go bad in the wire, sometimes inside of the mic. The wires are so thin, excessive use wears them out sometimes. Depending on the model countryman that you are using...I've seen them become disconnected where the mic. meets the wire...some can disconnect here beneath a rubber coupling...if you have this model, make sure that it is properly seated.
If there are no shorts in the mic or cable, and you only hear the popping while speaking into it, you may need to filter out the low end on this channel only (everything below about 120hz - 180hz)...and try using a wind shield to help control this.
Hard to troubleshoot without being there, but I hope this gives you a few good ideas.

Posted on Mar 30, 2008

  • 1137 Answers

SOURCE: need to wire a Sony ECM-77 to a Sennheiser ew-500 Body Pack

I hope this is similar:http://www.trantec.co.uk/PDFs/Wiring_for_Mini_XLR.pdf This is their tech link:http://www.trantec.co.uk/html/p_Tech_Info.htm Here is the beltpak info:http://svc226.bne095u.server-web.com/manuals/Senn500.htm Hope this helps somewhat.

Posted on Sep 01, 2009

  • 1 Answer

SOURCE: The countryman E6 mic caused a loud bang during use.

It appears that the "bang" was the result of a static discharge from the mic boom. I trust it doesn't happen again.

Posted on Nov 05, 2009

  • 211 Answers

SOURCE: what would it cost to repair the on/off switch on

Hi,

To repair the on/off switch of the handhelt it would cost abt 15 minutes and $2,00 for the switch.
So that would be $20-25.

Reagrds Gerard

Posted on Oct 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pastor Steve Bradcovich


God's Laws of Promotion - Pastor Steve Bradcovich - 9/3/2014 ...

? 36:04
https://www.youtube.com/watch?v=pYTKYFtf1eU
Mar 10, 2014 - Uploaded by Washington Community Church
God's kingdom has laws just as any kingdom does. In this new series Pastor Steve Bradcovich shows how ...

Resetting Your Life's GPS #2, Jan 4 2015, Pastor Steve Bradcovich ...

? 43:05
https://www.youtube.com/watch?v=TvZiRBrUrE4
Jan 5, 2015 - Uploaded by Washington Community Church
A GPS is great if it works. Because let's face it, if it doesn't know where you are as a starting point you'll ...

Moodswingers 5, October 9th 2016, Pastor Steve Bradcovich ...

? 33:45
https://www.youtube.com/watch?v=4l0LsQ8VTuc
Oct 10, 2016 - Uploaded by Washington Community Church
There are many things that can lead to burnout: stress, lack of exercise and poor diet, and we all know that lack ...

Moodswingers #1, SEP 11 2016, Pastor Steve Bradcovich ... - YouTube

? 30:30
https://www.youtube.com/watch?v=SNKkRp1VGNI
Sep 19, 2016 - Uploaded by Washington Community Church
Emotions are powerful. How powerful? Well, through history we see that emotions were the root cause of the fall ...

Pastor Steve Bradcovich and His beautiful wife Pastor Zury! - Yelp

https://www.yelp.ca/biz_photos/washington-community-church-alexandria-3?select... Feb 7, 2016 - Photo of Washington Community Church - "Pastor Steve Bradcovich and His beautiful wife Pastor Zury!" - Alexandria, VA.
Pastor Steve Bradcovich Google Search



Apr 12, 2017 | Computers & Internet

1 Answer

How do i sync my mic to my receiveri have a ew 100 g3 and after some kids were playing with it, I can't get any sound


Pressing the sync button whilst holding the mic close to the IR unit on the receiver should sync things back up. If this has already been done things to try next are as follows.

RF Mute. Press and release the power button. RF Mute should be displayed. Press the roccker switch and select RF mute OFF, press the rocker switch again.
Check in the advanced menu that the pilot tone is on on the handheld AND the receiver.

Jan 23, 2014 | Sennheiser Evolution G2 100 Series UHF...

1 Answer

How do you troubleshoot phasing issues with the Sennheiser 135 G3 wireless microphone?


Phasing issues? Not sure what you mean by phasing. Phasing would be the phase of the audio pressure on the mic versus the electrical phase out of the receiver. DO NOT EXPECT the phase to be stable in any way as there is a communication and data conversion in the loop. The phase will be highly audio frequency dependent as well.

May 14, 2011 | Sennheiser EW 135 G3 Microphone

1 Answer

I feel that the 'normal' background hiss is a problem that I would like to minimize with the sennheiser IEM 300. I'm currently using the IE 4 ear phones. Would a different/better earset with maybe a...


No, that will not help. The his is a function of the receiver NOT receiving a signal from the transmitter as they apparently do NOT have a "squelch" circuit to mute the receiver noise when no signal is being received. The noise level when no signal is received is pretty high and apparently the volume control is not enough to reduce the hiss.

To solve this, LEAVE the transmitter ON and make yourself a switch at the receiver. DO this using one of those little in line lamp switches that fit on zip cord. Make one on a short length of zip cor with mating connectors to fit the received jack and the headphone plug. Don't worry about unshielded wire as the impedance is very low. Then you use this switch to mute the headphones when you want to. There are other switch types you can use, I am just suggesting what might be readily available to you.

Sennheiser SHOULD have include a mute switch on their unit as turning the power off on the receiver would be a pain. They could have used a volume control with switch to kill the audio line out... simple solution... oversight on their part.

Mar 25, 2011 | Sennheiser ew 300 IEM G3 In-Ear Wireless...

1 Answer

The ew 3000 iem (brand new) is stuck on mute. Tried everything to no avail. Ideas????? Please Help!!!???!!!!


Hello,
To get your transmitter out of mute press the standby button and hold it briefly until "RF Mute Off" appears. Your display should change from red to orange and the transition icon will also be displayed again. This indicates your transmitter is transmitting.
Regards, Tony

Mar 24, 2011 | Sennheiser ew 300 IEM G3 In-Ear Wireless...

1 Answer

How do I un mute the pack


It looks like the mute function is only available from the menu... not very user friendly at all... I guess they figure the performer doesn't need to mute easily or quickly... Volume control I suspect is all that is readily availab;le at the pack to quickly mute.

Mar 13, 2011 | Sennheiser ew 300 IEM G3 In-Ear Wireless...

1 Answer

Disturtion in one left channel and bad quality in right channel


Make sure you are NOT overloading (clipping) due to excess signal into the transmitter end of this unit. Reduce the gain INTO the fixed unit and see if the sound improves.

Feb 23, 2011 | Sennheiser ew 300 IEM G3 In-Ear Wireless...

1 Answer

Some Headphones have an inherent hiss noise when they are connected to my wireless sennheiser EK 300 IEM G3 receiver. It seems to be a problem particularly with high-end IEMs which are highly sensitive...


Hiss is a problem of statistical noise in electronic devices due to the laws of physics plus circuit design.

One thing to do is to improve the signal to noise ratio (SNR) by properly setting gains. It is POSSIBLE that the IEM's you are using are too low impedance for the receivers resulting in you having to use excessive gain at the receiver. Your receiver gain control should not have to be above 60% of the way up. If you are above that, the ear buds are probably lower impedance than the receiver is designed for... and remember the manufacturer will LIE on the capability of the thing they are trying to sell.

The receiver is speced at 32 ohm drive... IF your ear buds are less than that impedance, they are NOT suitable. Conversely if they are too high, thaat will ALSO cause you to turn up the receiver gain too much and result in poor SNR.

You want to make sure the transmitter is being driven at line level so receivers get adequate input audio so gain doesn't have to be run too high.

Jan 04, 2011 | Sennheiser ew 300 IEM G3 In-Ear Wireless...

1 Answer

The countryman E6 mic caused a loud bang during use.


It appears that the "bang" was the result of a static discharge from the mic boom. I trust it doesn't happen again.

Nov 04, 2009 | Countryman E6 Ear Professional Microphone

2 Answers

Transmission distance problem on Sennheiser G2 wireless


I regularly use G2 ew100+300 systems, which have a manual squelch adjustment on the reciever. Squelch is difficult to explain but here we go: a squelch adjustment gives you the options LOW, MEDIUM, HIGH these settings effect transmission distance and interference rejection. for example: a HIGH squelch is less prone to interference but has a shorter transmittion distance. A LOW squelch is more prone to interferance but allows for a longer transmission distance. For most applications, a MID squelch is fine. If this does not help- the next option would be to swap arials between units and see if the problem moves. The G2 series are a 30mw transmittion which has an effective range of about 50m
hope this helps.
Rus.

Feb 15, 2009 | Sennheiser SK 300 G2 Wireless Bodypack...

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

5017 Answers

The Knight
The Knight

Level 3 Expert

73691 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...