Question about Laguna Pressure - Flo Uvc Filter: Pf 2100

Open Question

My Laguna garden water pump stopped working all electrical problems have been eliminated

Will not pump water.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central heating pump stops running


If you can not hold your hand on the motor for a count of 10 when it has cut out, the motor has overheated and needs to be replaced or find some reason for an overload.

Jun 21, 2017 | Grundfos Garden

1 Answer

After thoroughly cleaning, including removing impellor, water flow all but stops after several hours and then the pump shuts down completely.


It almost sounds as if the thermal load protection fault is being tripped on the pump. When the pump kicks off is the housing extremely warm? If so you may need to replace the pump.

Sep 08, 2013 | Laguna Garden

1 Answer

Where do i put power steering fluid in a laguna


Problem here ?? what type of laguna as up till about 99 it was a manual hydraulic engine driven pump later ones had a electric over hydraulic unit at the front right side just behind the bumper ,top up on top of the unit later models have a electric motor under the dash with no hydraulics but a direct drive to the steering column which needs special software to reset the straight ahead position but this is a renault the pain vehicle of my life ,best advice is to buy a old XJ6 sovereign jag if your mileage per year is low

Sep 24, 2012 | 2000 Renault Laguna Estate

1 Answer

Laguna water garden pump just quit working


Possible causes: Electrical or Mechanical. For Electrical - Check to make sure power is coming to the outlet/cord it is plugged into. If there is a GFCI on the circuit, make sure it is reset.
Mechanical: If something got sucked into the pump it may have caused the impeller to stop and/or the pump to overheat. Some models have an thermal override that will shut the pump off if it overheats. If it is a magnetic drive pump, the impeller can probably be saved, if it is a direct drive, it may have gotten damaged by the jam. Unplug the pump and carefully disassemble the portion where the water goes in to determine if something got sucked into the impeller mechanism.

Aug 07, 2011 | Garden

1 Answer

Max Pro 1500 motor starts but then stops within 10 seconds. Does not run continuously. Cleaned inside and put back together but problem still continued.


Your problem is the thermal switch is tripping off. this means there is some supply or voltage problem. Most likely fix is replacing the capacitor.

Jul 19, 2011 | Hagen Laguna MaxFlo 1500 Electronic...

1 Answer

How do i stop the syphan effect after the pump turns off, when my water tank is higher than outlet..garden


That is a great question.
The only things that I can think of are installing a valve or raising the discharge line higher than the water level in the tank.
The valve could be hand operated or electrically operated to shut when the pump stops.
Also, if you could run the pump discharge up to a point higher than the water line and install a vacuum breaker at this point and run the line back down to where you use the water, when you shut the pump, the siphon suction would open the vacuum breaker admitting air and stopping the siphon.
Let me know what you end up doing.
Gary

May 14, 2011 | Plumbing

1 Answer

Kenmore dishwasher various problems


The portable dishwashers of the 70's and 80's often had one area of problem, and that was the pump getting jammed with debris and food.

To eleminate this problem, you will need to open up your dishwasher carefully, and drain all the water and gunk from your dishwashers rinse hose. I recommend taking the machine outside and use a low setting pressure hose (garden hose). With the hose off the rinse side, run the water through and see if it comes out of the pump's housing. Let it run for a few minutes.

The pump also has a switch that also goes with the run cycle. This switch thinks there is not enough water or it thinks it has done its job.

Sometimes replacing the timer helps, but first eliminate the lower hose situation first. If that doesn't help, you will need to then replace timer. If this doesn't help, most likely your pump is most likely jammed or malfunctioning.

May 24, 2008 | Dishwashers

Not finding what you are looking for?
Laguna Pressure - Flo Uvc Filter: Pf 2100 Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Laguna Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

roeb

Level 3 Expert

603 Answers

john h

Level 3 Expert

12650 Answers

Are you a Laguna Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...