If you don't use 9 for an outside line, you can usually enter 9850 to clear alarm messages on your phone. If that alarm keeps popping up, the cable coming from the wall might be faulty or the port on the switch is going bad.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
On the radio, repeatedly press the Alarm Mode button until the desired alarm mode indicator below "Alarm" is displayed. The music note indicates radio and the sound waves indicate the alarm tone. If no icons appear on the display, that means the alarm is turned off
Radio and tone
To turn alarm 2 on/off, follow these steps:
Turn the system off
On the radio, press and hold the Alarm Set button. "Alarm" flashes on the display
Release Alarm Set, and repeatedly press Alarm Mode until the desired alarm mode indicator above "Alarm 2" is displayed. If no icons appear on the display, that means the alarm is turned off. The "Alarm 2" indicator will continue to flash on the display for 10 seconds. When the flashing stops, alarm 2 is set
If you have an after market alarm sys. take it back to who ever installed it . as far as the key & lock sys . spray some WD40 into the lock and try again . disconect the alarm speaker until you figure it out . Good Luck
permanently? changed in 96. so,... sys. p/n is a dash ..61 now.. i guess you lost the remote fob? or is dead or bad. (programming?) turn the valet switch to on. its now dead. (on dash switch)
way 2, remove the alarm fuses. the controller has 2 inline fuses, behind the glove box. to pin 11 and 12 of controller, RED and GREEN wires. remove the internal in line fuses, 10A and 12a.' warning !:once, done , fuse pull the main controller forgets the FOB key codes, and must be relearned. need a manual ask.
The steering lock may be binding the ignition lock cyl preventing the key from turning or the key may be worn out. Try turning the steering wheel back and forth while wiggling and turning the ignition key. To get the alarm to turn off without starting the car try locking and unlocking the vehicle from the passenger side door. There is a micro switch on the drivers side door lock cyl that may be bad and preventing the alarm from dis arming. This is all providing it is a toyota factory alarm sys.
This worked for me, from a Sony Tech. 1) When SYS ERR is displayed turn off the player by holding down the power button until tghe unit turns off. 2) Unplug the power cord. 3) Wait a minute or so and plug the player back in. This reset the player for me.
1) enter bios 2)make changes in shared graphics to 128 mb 3) increase the size of page sys file allocate more ram to page.sys file by going into rt click my computer/properties/ performance/ 4 u can change your windows system to 64 bit.
Here are the instructions to view, change alarm time and turn off alarm:
From normal time display:
Press MODE once to display stop watch. Press MODE again to change alarm time. Press MODE again to change time.
From normal time display:
Press RESET once to display current alarm time. Press and holdRESET then press START to turn on and off alarm (watch for alarm symbol on top left) Press and holdRESET then press MODE to turn on daily alarm vs one time (watch day marker lines at the bottom)
Hope this helps.