Ribbon fault printing empty pages

laser printers have small PCBs that count prints and tell you that the toner is empty based on count and not toner level. This may be the same

Sounds like the Print cartridge is empty, if not try cleaning the Ribbon at the point at which the cartridge seats in the printer, Use alcohol on a Q-tip. Replace the ink cartridge and use the printer self calibration. Worst case contact the MFG for support on your model, sometimes tech support will help in minor problems.

Your print solenoid probably has a broken cap. There are some companies that sell the "kit" with instructions on how to replace the cap.

First of all sorry for the problem.
It seems to be a logic card problem . Kindly contact with lipi for replacement of the logic card.

I'm including this link to the users manual:

http://www.zebra.com/id/zebra/na/en/index/resource_library/manuals.results.html

But here is the basic troubleshooting info for that issue

No print on the label.The media may not be direct thermal media when printing without ribbon (i.e. thermal
transfer). See the test procedure

Determining Thermal Media Types on page 29.
• For thermal transfer printers, the media may not be outside wound or approved for use in
the G-Series printer. See the following ribbon test procedures: Ribbon Test with Adhesive
on page 32

and Ribbon Scratch Test on page 33.
• Is the media loaded correctly? Follow the instructions for

Loading Roll Media on page 11
in the Getting Started section. For printing using transfer ribbon, see

Loading Transfer Ribbon
on page 14.

Your take up spool isn't working properly, bad motor or belt.

Reset the printer to factory defult

PR-01726 Ribbon Out
Out of print ribbon.
Possible Cause 1 : The print ribbon Cartridge is empty.

Solution 1 : Reload the print cartridge. Change the cleaning sleeve and replace the cartridge in the printer. Run a cleaning card as soon as printing is completed.

Possible Cause 2 : The printer ribbon is not loaded correctly.
Soultion 2 :Load the printer ribbon correctly and then close the cover.

Possible Cause 3 : This ribbon has been completely used.
Solution 3 : Use a new roll of ribbon.

Tips for Success
* When this message appears, replace the old ribbon with the new ribbon of the same type. The printer has already prepared the card data for this ribbon type. You can change the colors of monochrome ribbon (such as from dark blue to gold).

* If you must change the type of ribbon (such as (YMCKT to KT) when this message appears, install the new ribbon, cancel any cards waiting to print, and change the ribbon type settings. Finally, return to the card creation program to send the card data to print.

* If the ribbon was repaired, the wrong take-up spool was used. Repair the ribbon again, using the correct take-up spool.

If you cannot fix the problem contact your service provider for assistance.

FTB

Try changing setup from thermal transfer to direct thermal

Hi my tally printer 6218 giving Ribbon motion fault, what could be done to remedy this error message ?