Question about 2wire 2700HG-B Router (2700HGB)

Open Question

Power LED solid red

First of all, I am surprised that so many people has the same problem, which is very likely related to the power adaptor failure. I am glad that I saw this thread. Following the suggestions, I checked a local RadioShack store. Unfortunately, they do not have any of similar specs. Then I went to Fry's and got one adjustable power adaptor with interchangeable tips and 2500mA rating. Unlike typical adjustable adaptors with 4.5V and 6V, this one has 4.2V, 5V and 6V, and the 5V works! Even though it is a bit more expensive ($18.99+tax) than the one from the web ($9.99+shipping), it is the quickest solution for me. I am happy that I did not spend $79 for a new gateway.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Ryd66
  • 65 Answers

SOURCE: modem power adaptor

On the bottom of the Modem, it usually lists the type of voltage/current ratio, for example, My modem is a 12VDC in, output is .75A Through the modem. Each modem has its own power requirements. Therefore if they dont match, you have the chance of either underpower (which means no use) or overpowering (and killing your modem permanently)

Best suggestion si the same as above by cnavarro, Buy the Right power supply for it, dont just try anything. get the matching one. Otherwise it will be Incident A or Incident B. Neither would work well, and you would end up buying a new modem all together.

Posted on Oct 31, 2008

Ad
zohail
  • 1223 Answers

SOURCE: Solid red power light

pls check the power supply this happens when the router's supply is faulty or the power outlet in WALL ,

otherwise try this see for RESET button on the back of Router press it for 30 SEC when ur router is ON and it will resolve for sure let me know if it doesnt solve i can help more

RATE ME WELL !

Regards

Zohail

Posted on May 21, 2009

  • 60 Answers

SOURCE: Solid red LED for power, Solid green LED for wireless

You can try upgrade the firmware of the device first and then reset to factory default.

Posted on Jul 16, 2009

alexgalapin
  • 148 Answers

SOURCE: I have a 2 Wire Switching adaptor that went bad.

  • generally it has no problem on that
  • what matter is the adapter voltage and ampere is compatible to the router
  • if you know to do it properly go ahead

Posted on Aug 12, 2009

  • 1 Answer

SOURCE: 2wire 2701HG-B got red light on power & green light on wireless

I had the same problem. I replaced it with my psp adapter instead now it works fine.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nec vt540 vt540k


probably needs filters cleaning or a new lamp replacement.

Oct 07, 2013 | NEC VT460 Multimedia Projector

2 Answers

No sound or picture. red timer light on. wd60735


Hi there,

This model as 3 LED indicator lights:

1) Power/Timer 2) Status 3) Lamp


If "STATUS" LED is blinking RED:

1) Internal Fan has stopped. These tv's require fans, to prevent overheating and causing damage.

If "STATUS" LED is solid RED:


1) Circuit failure (short)
2) Disconnected DVI cable, chassis to engine
3) No LAMP-EN signal from Engine to turn the lamp On.
4) Ballast UART communication problem.

If "LAMP" LED is solid RED:

1) Lamp Failure - Lamp failed to turn On.
2) Lamp is broken (e.g. burst or blown)
3) Lamp turns Off during P-ON

There is no data relating to TIMER LED being solid RED.

Hope this helps.

Cheers,

Scott

Feb 01, 2013 | Mitsubishi Televison & Video

1 Answer

Power led solid red, internet led solid green


This is a sin of a bad unit already, first thin that you can try here is to reset the router by pressing the reset button of the device for 30 seconds , but after that and still the same light better contact your device manufacturer...

Sep 15, 2009 | Actiontec GT704WG Wireless Router...

1 Answer

Dell 1505 Inspiron... Dead?


Motherboard failure, you can buy one on Ebay for about $100.
To confirm, remove RAM, Drives, battery and wireless cards, see if the LED indications change. If no change, then the MB is confirmed bad. If they change, add 1 RAM module back, see if the system will post enough to get into BIOS. If it does, add other RAM module. Keep adding items, (Wireless, battery, CD Drive, then HDD) and ID the one causing the failure.

Jun 09, 2009 | Dell Inspiron 8500 Notebook

1 Answer

Internal led of ML350 server is glowing.......how do i resolve it?


Hi Franceso, plz specify
Is it powering ON ?
Which LED is glowing?
These leds are there on the front panel :

1 Power On/Standby button
2 System power LED
Green = Power on
Amber = System shut down, but power still applied
Off = No power

3 Internal health LED (Wave sign in BOX)
Green = Normal
Amber = System degraded. To identify the component in a degraded state, refer to system board LEDs.
Red = System critical. To identify the component in a critical state, refer to system board LEDs.
Off = Normal (when in standby mode)

4 External health LED (power supply)
Green = Normal
Amber = Power redundancy failure
Red = Critical power supply failure
5 NIC 1 activity LED Green = Network link
Flashing = Network link and activity
Off = No link to network.
6 UID LED Blue = Activated
Flashing = System remotely managed
Off = Deactivated
7 UID button

If it is Internal health led then any internal h/w issue is suspected.
If it is external health led then any power supply or power source related issue is suspected.
Also check the status of the server & its IML (Integrated Management Logs) in ilo (Integrated Lights Out ) if it is configured. (2nd RJ45 port in rear)

Also make sure the cabinet is properly closed.

Nov 18, 2008 | HP Compaq ProLiant ML350 G3 Server

1 Answer

Diagnostic Indicator


Beep codes and power LED status are pre-post errors. Usually beep codes indicate a problem with a memory module. Power LED is solid green for normal operation. Solid or blinking Amber color power LED indicates a power distribution problem.




Your responses are intended to improve the level of service provided. Please show your appreciation by rating your experience.
Thank You.

Nov 13, 2008 | Dell Dimension 2400 PC Desktop

1 Answer

Xbox 360 adapter


The flashing yellow light on the Power adaptor points to a potential failure with the power adaptor. Usually when the adaptor is idle their is a solid yellow light, A red light for a total failure and a green light for on.

A YEllow flashing light would indicate that there could be potential problems with the adaptor overheating and/or being faulty. where is the adaptor located ? just like the console itself. they are prone to overheating and collect dust very easily.

i would suggest moving the adaptor into an area with a large opening to allow the flow of air to keep it cool, also i would attempt to remove any dust inside.

Try doing this and if the problem persists, let me know

Oct 25, 2008 | Microsoft Xbox 360 Console

1 Answer

2wire router


ANOTHER COMMON ISSUE: If your modem keeps restarting once the power LED turns solid green, the most likely cause is the power adaptor. Replace the power adaptor and all should be well again.

Jul 11, 2008 | 2wire 2700HG-B Router (2700HGB)

1 Answer

ILo tv


It looks like the power supply failed on your TV. If the LED is solid red or green, it could be some leaky or dry capacitors but if the LED is blinking, the failure is more complicated to repair.
I service these power supplies. If you need more info you can send me an email to jah2mil@hotmail.com

Jun 04, 2008 | iLO LCT32HA36 Television

Not finding what you are looking for?
2wire 2700HG-B Router (2700HGB) Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top 2wire Computers & Internet Experts

Prashant M
Prashant M

Level 3 Expert

2260 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Bruce Silvernagle
Bruce Silvernagle

Level 1 Expert

17 Answers

Are you a 2wire Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...