Question about Cuisinart DGB-600 Coffee Maker

Open Question

Water leaking under base

Water leaking under the base

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Seem to have water leaking under shower into storage competition ment, tried caulking only happens when shower is on and someone is in it very frustrating


Very often happens for a number of reasons

Bad caulking around the shower base and the base drops with the weight of the occupant allowing water past the caulking.

Crack and bad seal on a wall tile.

A split in the base itself which opens up with weight and you can't see with the base empty.

A leak in the pipes behind the wall from the mixer unit to the shower head.

Split pipes or fitting to the drain.

Best way is a full tear down, refurbishment and start anew :>)

Jul 10, 2016 | Home

1 Answer

E15 i want reset it ?


If this is a Bosch dishwasher, the E15 error indicates water in the base of the unit. You need to unplug the dishwasher and pull it out (if it is an under-counter unit) carefully. Empty the water from the base. Sometimes tipping the unit so that the base is tilted 45 degrees from the floor will help the water flow out. Make sure that the entire base is dry.

Replace the dishwasher under the cabinet (if needed) and plug it back in. If the error repeats at the next cycle, you need to determine where the dishwasher is leaking. It could be the outlet hose, the pump or the tub. Replace the bad part. If the dishwasher is under warranty, contact Bosch.

I hope this helps.

Cindy Wells
(if you recently had a flood either under the kitchen sink or an overflow at that sink, you just need to dry the dishwasher base.)

Apr 16, 2015 | Dishwashers

2 Answers

When installing do you silicone each piece for example the faucet , the soap dispenser ,the sprayer , and the tap


Hi seawitch678,

If you have a granite or stone countertop/sink, use silicone as plumber's putty will stain the stone. Plumber's putty is petroleum based so it will not adhere to stone. Normally you should use what the manufacturer recommends and where they recommend. When installing a faucet, put either around the base of any piece that goes through the countertop.

Hope this helps. If it does, I'd appreciate your vote. Thanks,

Handie Andie

Jul 15, 2011 | Price Pfister Marielle Kitchen Faucet with...

1 Answer

Solaris Model #06544860 leaking under the sink. How do I remove and how do I figure out exactly what is leaking?


The first thing I would do is to locate source of the leak. Look carefully at faucet when it is on and see if you have any water leaking from areator and running back down the underside of spout and leaking around base of faucet, also see if you have any leaks around handle. If the leak is from the areator you can just replace it and not have to remove the faucet. when you check under sink on faucet supply lines make sure they aren't leaking at that point. I would use paper towels or rags to wipe everything dry under faucet and let it set for 1/2 hour then check again. If it.s still dry run some water and use both hot and cold water seperatly,checking underside in between. If you determine that leak is coming from top side and leaking thru. Shut off water supply valves if available if not shut off supply to house, make sure water is off before proceeding. Disconnect supply lines from faucet,Remove retaing nuts on either side of base,and remove washers. Remove faucet and check for any obvious faults. If you think it was leaking around base get a small tub of plumbers putty. Most hardware stores stock it. Remove a golf ball sized portion or larger and knead in your hands until it is warm and pliable. Press into place in faucet base. Continue doing this until it's full. Reinstall plastic or rubber base gasket and put faucet back in place Put washers and retaing nuts back on a tighten till snug. Center faucet where you want it and tighten securely. Scrape off excess putty with knife point and wipe with paper towels till clean. Hook up supply lines and turn water back on. Check for leaks and good luck. Thank you

Nov 27, 2010 | Hansgrohe 06649860 Solaris Single Hole...

1 Answer

F1 code how to fix and re-set


Is this happening with both drawers or just one.

You have water leaking into the base of the dishwasher under the drawer.

Most likely the drawer seal is leaking.

The flood switch is located at the base of the dishwasher and this needs to be dried.

Turn power off and take the bottom drawer out. Dry base with towels and hair dryer. Turn power back on without putting the drawer back.

Run top drawer to see if any water is leaking.

Water leaks can be due to faulty seal or drain hoses cracked.

Hope you are able to fix it.

Sep 11, 2010 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

Need a service person. Machine reads F1 and must unplug to stop it from running


Is this happening with both drawers or just one.

You have water leaking into the base of the dishwasher under the drawer.

Most likely the drawer seal is leaking.

The flood switch is located at the base of the dishwasher and this needs to be dried.

Turn power off and take the bottom drawer out. Dry base with towels and hair dryer. Turn power back on without putting the drawer back.

Run top drawer to see if any water is leaking.

Water leaks can be due to faulty seal or drain hoses cracked.

Hope you are able to fix it.

Sep 07, 2010 | Fisher and Paykel 23 in. DD-603SS Built-in...

2 Answers

Eco light comes on when I switch on machine but can't change programme and it doesn't work some water still under filter


This indicates water in the base, there is a polystyrene float that operates a cut off switch if water leaks into the base, this could be caused by a leaking pipe connection, or simply by water getting by the door seal and eventually having enough volume in the base te operte the float switch, try tilting the machine backwards if water comes out of the basethen this should cure the problem, but if it recurs fairley quickly you should have the hose connections checked for tightness, can be accessed from the base.
the dishwasher should be isolated from the supply first base tray is secured by 6 screws, the float switch is attached to the base so care should be taken when removing the base tray

Apr 23, 2010 | Hotpoint 24 in. FDW60 Free-standing...

1 Answer

Leaking under sink and st base on sink


Remove spray head then faucet tighten connection on the spray hose

Sep 25, 2009 | Danze D403412 Melrose Single Handle...

1 Answer

Water leaking into machine


This happens when the boiler develops a leak, usually due to scale buildup. Order a new boiler and o-rings and replace.

Sep 29, 2007 | Saeco Magic De Luxe Espresso Machine

4 Answers

Water leaking into machine


it's possible, like mine with the same problem, that one or more of the plastic feet under the water tank has broken, then making the tank move and upsetting the valve underneath. My one always leaks clean water, never dirty and I have a broken foot.

Sep 29, 2007 | Saeco Primea Cappuccino Touch Plus Coffee...

Not finding what you are looking for?
Cuisinart DGB-600 Coffee Maker Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cuisinart Coffee Makers & Espresso Machines Experts

Greg Cann
Greg Cann

Level 3 Expert

1114 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

littlechum55

Level 1 Expert

19 Answers

Are you a Cuisinart Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...