Power cord hd1000u2e

It's possible that the power supply is broken, which moves power from the battery/power cord to the rest of the computer. This requires soldering to repair. However, there are a number of things which could be wrong with the computer, almost all of which will require a technician to repair.

The printer requires to be plugged into the power source with the power cord connected to its power adapter to function. Please contact Lexmark technical support for assistance if you lost the cord or the adapter. Thanks.

The "physically-smaller" external hard-drives draw power through the USB cable.
The "physically-larger" external hard-drives require an external power-supply (just like a laptop requires an external power-supply).

Check the casing for a plug where the electrical power would come in; if none, then the unit will draw electrical power through the USB cable.

For many older Norelco shavers, such as this model, the power cord simply connects 110 VAC to the shaver. The principle voltage reduction and current limit circuitry for the motor and battery charging are within the shaver. That is why the cord is just a cord, available for under $5 online (<$10 with shipping), without a housing for a transformer or electronics within the cord.
　
The amperage will likely be very low, e.g. <0.1A, but I do not have access to this model for checking actual requirements.

Hi,

This is due to a faulty cord or a damaged power inlet on the motherboard. Hope for your part it is the cord. Try a new power cord and if it doesn't work I'm afraid you might have to replace your motherboard...

Cheers

Consider the following...

• plug a lamp or another device that requires electricity into the spot the wii power cord is.
• take the power cord out the wii, locate another wii power cord and try that one or vice versa
  

that means the power cord is faulty, the monitor does no send message to the power cord rather the power cord sends message to the monitor so its the power cord that's bad expecially if its an adaptor, thanks

There is no power cord required for an M7310 set. The set gets all the power from the Nortel telephone system. Try plugging in your phone where another phone is active to ensure that your phone that you want to install is working. The phone flashes, then stops, then flashes, then stops... you just have to be patient when testing. Possible Troubles: -> It maybe the line cord, the cord that plugs in from the wall to the phone that can be damaged. -> the jack might be dead (wiring in the jack is pulled off) or inactive (there is no jumper from the office to the telephone system). -> the phone port from the telephone system might be dead.

The link you offered is for a standard IEC computer power cord. (click the camera next to the item #) Problem is, if you look at the scanner, there is nowhere for that type of cord to connect. I believe the scanner requires a power adaptor, Look next to the power jack to see what voltage is required, it may be 24 volts or 30 volts for example.

look at the back of your lcd it usually will state the voltage and power requirements of the required replacement adapter...never exceed the voltage requirements this may cause damage DO NOT USE THE 16V ADAPTER!
The adapter you require appears to be rated at 12V x 5A a 60Watt unit you can replace most likely with similar switch mode unit rated at 12V and at least 5A or more