Power Window on Drivers door of a 2003 Grand Jeep Cherokee will not work

From our Pro Technician.

Anonymous Mar 08, 2022

Look for broken wires inside the flex boot , black rubber boot from the body of the vehicle to divers door. That year vehicle happens a lot after you open the door a million times.

Find a good local auto-electrician.

your master control module is bad..we just did this with a close friends' jeep.. it went all funky and I couldnt figure it out at first..the dealer we took it to fixed it because it was and still is under warranty.. thats what was wrong with hers..

Check the switch module for disconnected.

Wiring Loom between door and body breaks internally. Take the car to an Auto Electrician and they can repair the loom. It is quite a common problem.

sounds like an open power or ground circuit on passenger side,since the door lock and the window,lost its functioning.Both switches would have to be bad at the same time,which is not probable, to be the fault. Unless there is a saftey lock out switch on the drivers panel,controling the passenger side door lock and window.

You would have to take the door panel off to take the window motor off, then run jumper wires to the window motor terminals. If the motor doesn't turn, time to get a new one. But more than likely, if all the windows don't work, it may possibly be a fuse. Also, you might want to check the window switches, they do burn out. I have had to replace a couple on my 1993 Jeep Grand Cherokee.

I WOULD CHECK THE WIRING BETWEEN THE DRIVER'S DOOR AND THE POST..YOU WILL SEE A RUBBER BOOT BETWEEN DOOR POST AND DOOR..HAVE SEEN PARTIALLY BROKEN WIRES CAUSE ALL SORTS OF PROBLEMS HERE

driver side lock and window switch... if its all one unit... i had a 95 cherokee laredo that did that... changed the switch and it fixed my problem...

Hold up on the switch and slam the door. If it is the motor this should work at getting it up. Hard to believe that both switches would go bad at the same time.