Question about Computers & Internet

Open Question

Pictures of worms

Hi I think a fly laid eggs on my skin.Its verry large like n sits on my back.About n year ago my haed was verry itsey and then n small worm game out of my head.What can a drink to help me.THANK YOU

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: sansui tv sv2918

replace vert IC301, C432, ( D431 & R431 should also be blown)

Posted on Nov 26, 2008

Ad
  • 6 Answers

SOURCE: hobart A200 mixer motor worm gear

sometimes you read of other problems and solutions and it puts you at the edge of your seat. in this case of changing the worm gear on the A200F was cake. when you drop the lower end (3/4 acorn and jam nut), pull out yoke (speed select handle) the center transmision shaft and gears pull right out.worm gear easy to change at this point. if you can change a motor bearing, then you can do this job. Note: change seals and bearings as needed,check all gears,keys and spacers for wear and if you go the mile take gears off drive gears, these are the 2 smaller trans shafts put in lath if you have accsess to one if not roll shafts on flat surface to see that shafts have no bends in them. Also remember when you put the bottom back do not over tighten the jam nut,hold and lock acorn nut, should spin free and have about .016 to .030 movement up or down. Lay out all part on cardboard the way they came out. should go back together easy.

Harry Ooooooooooo

Posted on Jan 13, 2009

rowdy45176
  • 2176 Answers

SOURCE: I need to know how much oil goes into a skilsaw worm drive resvr.

Haven't heard anything so I checked the Milwaukee worm drive saw and they recomment about 1/2 oz. Make sure you use an oil for a worm drive that is not foaming. Hope this helps. Also when checking oir level have the shoe set for max depth and on a flat surface remove the oil plug, when filling tip the saw on its side and fill, turn back over and allow excess oil to run out if overfilled.

Posted on Jan 24, 2009

SOURCE: w32\gaobot.worm.gen.u-win32\rbot.3eu.worm

click here

Download quick heal antivirus
Click here

downlaod avast antivirus from above link.

click here

download malware removar from above link.
Download these 3 antivirus then install 1 by 1 in computer then update it's definition from internet .
Then scan your computer in boot time.Then it removes all virus.
Make sure after scanning with 1 antivirus uninstall that antivirus then install seconds antivirus.
Then all virus are removed.
Let me know if you need further assistance.
Thanks.

Posted on Nov 04, 2009

priyat2216
  • 11 Answers

SOURCE: small worms in dogs

That may be flea and ticks, you should remove these worms.These tiny bloodsuckers can make your pet's life miserable and can even spread profanity. This could cause serious harm to your dog. This is the reason why it is a great idea to be equipped with all the right flea and tick products so that you eradicate them the second they infest your pet. By doing so, you will save your pet from a lot of pain.

Posted on May 15, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Who will believe I have Morgellones Disease so that I can get help?


Locate any eggs, larvae, pupae, and worms that you can. Put them in jars and freeze them (so they don't change). Call an exterminator and show your bugs to them, so they know what they are trying to treat the house for. Find a new doctor, bring your bugs, in the jars, in sealed plastic baggies, to show him/her.

GOOD LUCK!!!

Apr 01, 2017 | Miscellaneous

2 Answers

Help. I shut down my refrigerator when I moved. When I opened the door, I found the refrigerator full of maggots. I used clorox to clean it but I heard there could be eggs that I could not reach. Is...


Maggots are the larvae that have hatched from insect eggs. Yes, there might be eggs somewhere still in your refrigerator. I would suggest that you locate an insecticide (a bomb type perhaps) and set it off in your refrigerator BUT UNPLUG THE REFRIGERATOR FIRST. Close the doors and let the refrigerator stand for a week. After that time, you will need to carefully wipe down all surfaces with a mild soap solutions. Then rinse well. If there are still lingering odors you can wipe again with baking soda solution or you can place activated charcoal in the refrigerator to absorb the pesticide odor. I had this same thing happen in a foods lab with a microwave oven. I used this procedure and never had maggots again. You don't have to be a dirty person to have problems like these! I hope this helps. If it does, please come back to Fixya and rate my advice!

Jul 28, 2011 | Refrigerators

1 Answer

Exterior paint is pitting (chipping)


You didn't mention how old your Egg is, but if it's been sitting out, uncovered in the weather for a couple of years, that's probably playing a role in why it's chipping. Especially, if freeze/thaw weather.

If none of the above is the case, the fired finish may have had air bubbles in it. If the Egg is no more than a year old, contact the manufacturer concerning this. They are good folks and will try to do their best to help you.

Hope this helps and Happy Grilling.

Feb 19, 2011 | Big Green Egg Extra Large - XLHD...

2 Answers

Factory skins for various sx-70 models


Check Ebay for I have seen many sold there last year. Also google camera covering for I have purchased some years ago somewhere in the US on the east coast I do beleive. I think the name was Cameraleather.com

Dec 28, 2009 | Photography

1 Answer

Black holes where eyes should be


It sounds like your colour sensor is having issue deciding what colours should be what. To test this, take a picture of something else white, first try something large like a cloud or a white pillow from close up, see if it comes up black. Then try something like an egg against a different colour background, something skin toned would work best, or use yellow. If those come up white, you've got me stumped, but it is likely they will appear to be black.

Dec 08, 2009 | HP Photosmart R727 Digital Camera

1 Answer

2002 F150 truck won't start


is it an auot box? if so have you diped the atf fluid latley? if its very low that could do it? if its a stick shift it could be the starter or the ring gear slipping on the fly wheel worst thing i can think of is broken drive plate on an auot box or even a broken crank shaft?

Oct 26, 2009 | 2002 Ford F150 Regular Cab

3 Answers

I have enjoyed my egg and muffin toaster for some time but all of a sudden the heater for the egg portion is not working. Is there a part (fuse?) or something that I can purchase to get it working again?


What a coincidence! My neighbor brought over his back-to-basics a couple of days ago with the same symptom.

I took it apart but haven't completed testing yet -- but it's not going to be simple. I think it's the relay for the egg cooker. It's soldered in a circuit board -- most likely will need replacing.

Unless you have experience with appliance repair, you should probably take it to a shop.

May 09, 2009 | Back to Basics TEM-500 Egg & Muffin...

2 Answers

Need an egg boiler


http://www.focuselectrics.com/catalog.cfm?dest=itempg&itemid=3732&secid=53&linkon=category&linkid=98

Dec 05, 2008 | Back to Basics TEM-500 Egg & Muffin...

1 Answer

Slow rotation of the ceiling fan


Who do you think is 'you'? Electronics technician indeed. Take it down hot from running and find out what's sucking up all the juice; bearings, windings, controls, etc.

Don't take a year at servicing things if you can help it....

Aug 12, 2008 | Dryers

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

kakima

Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...