Question about Hotpoint 24 in. FDW60 Free-standing Dishwasher
If this happens within the first. 9 secs after filling it means you have a hearing fault
Posted on Mar 24, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: HOTPOINT DISHWASHER FDW60
I have just had my dishwasher fixed by Hotpoint, as the heater was working and the dishwasher only stopped with the fast and delicate lights just before the drying process he replaced the main control board. This has solved the problem, I suspected the fault to be the thermistor as the heater seemed to be getting to hot but I had no idea where it was.
It turns out the thermistor is attached to the main control board and hangs down behind the front door that gives just a rough temperature level for the main control board.
As it's soldered directly onto the control board I would suggest replacing the whole control pcb for anyone with this fault unless you can find any spec details for the thermistor.
Posted on Mar 23, 2008
I had a hotpoint engineer try to fix this type of problem.
He insisted that there was something stuck in the bottom of the pump.
Sure enough there was.
1. Unplug your dishwaser at the wall.
2. Remove the grill under the bottom rack.
3. Ensure that the filter is free from food and other obstacles and clean the filter.
4. Before replacing filter etc, get a piece of metal coat hanger wire and care fully insert it down the channel under the filter to free any lodged items. You may also see a small white impleller try to turn this with your finger or the coat hanger wire (this is the info from the engineer!).
5. replace filter and retry a wash.
This routine fixed or machine twice and will hopefully fix yours!
Please don't forget to rate me!
Posted on Jul 16, 2008
In my case it was the pressure sensor on the side of the short hose between the main (circulatory) pump and the bottom jet arm (which spins inside the machine)
Remove it and test resistance on terminals while blowing into the tube.
There is another pressure sensor on a hose attached to the waste assembly but appeared to be working correctly.
Posted on Apr 21, 2009
You most likely have a stubborn clog in your kitchen drain. Try filling the sinks with warm soapy water and then letting the water drain while also turning on your garbage disposal. Sometimes the extra water pressure will help push the clog through.
Posted on Jun 16, 2009
Tips for a great answer:
Sep 07, 2015 | Electrolux Washing Machines
Mar 30, 2013 | Candy CN146 Front Load Washer
Jul 21, 2012 | Dishwashers
Jun 12, 2011 | Hotpoint 24 in. FDW60 Free-standing...
Mar 31, 2010 | Malber WD1000 Front Load Washer/Dryer
Dec 21, 2009 | Hotpoint 24 in. FDW60 Free-standing...
Jun 16, 2009 | Hotpoint 24 in. FDW60 Free-standing...
Feb 21, 2009 | Roper RAS8445KQ Top Load Washer
Oct 31, 2008 | Haier XQG50-11 Front Load Washer / Dryer
85 people viewed this question
Usually answered in minutes!