Kenmore dishwasher no power - Kenmore 24 in. 15689 Built-in Dishwasher

Common solutions for: Kenmore Dishwasher will not start. The door switch prevents the dishwasher from running and working while the door is open. If the door switch is defective, the switch will stop the dishwasher from running even when the door is closed. If the thermal fuse has blown , it will prevent the dishwasher from starting.
Make sure your dishwasher is fully and also securely plugged in and that the circuit breaker switches haven't been tripped. .It also houses the door latch switch that provides the power to the dishwasher controls. If the dishwasher door isn't closed properly, the dishwasher won't receive power to finish a wash cycle You could call a repair person that fixes dishwashers to have a look at it and see what the problem is with the dishwasher

Only reset you can do is unplugging power cord for 10 minutes.
The control panel it is probably faulty and in need for replacement.

Un Plug

Here are four suggestions for you to try:
Kenmore dishwasher blinking light

Appliance Repair Forums

http://forum.partsdr.com/showthread.php?693-Kenmore-dishwasher-with-constantly-blinking-quick-rinse-light

https://www.askmehelpdesk.com/appliances/kenmore-dishwasher-model-665158240000-quick-rinse-flashing-64022.html

Hi Roger, Hope this helps......CHEERS..

KENMORE DISHWASHER ERROR CODES

Kenmore Dishwasher Error Code = Start Resume light blinking slow
When the dishwasher door opens or electrical power is removed during the cycle then the dishwasher will not start again. The door is detected as being closed and the Start Resume button is being pressed
Kenmore Dishwasher Error Code = Clean light is blinking 7 times
Heater circuit fail. Control panel did not detect the water getting hot. Did not detect heating element was energized to heat the water during the wash cycle
Kenmore Dishwasher Error Code = Sanitize LED blinking at end of cycle
Control panel could not detect if sanitation has been achieved
Kenmore Dishwasher Error Code = Console light blinking rapidly
There is a stuck button on the control panel
Kenmore Dishwasher Error Code = Clean light is constantly illuminated
Dishwasher cannot start a wash cycle until it sees that the door has been opened after the previous washing cycle
Kenmore Dishwasher Error Code = Control lock LED is ON but not responding to pressing of the keys
Turned on by accident or there is a control detected key pad problem

>> Unplug dishwasher power cable from wall mount also from dishwasher (if applicable).
>> After 10 minutes - plug the power cable from dishwasher to wall mount
>> Turn on the dishwasher
>> Try to operate the panel.

Try unplugging your dishwasher and waiting 30 seconds, and then plug it back in. See if that helps.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

it is most likely the door latch switch

The green is the ground wire. Attach it to the screw inside the junction box.

There will be a thermal fuse located on the electronic control board housing that may have failed.This replaceable part (gray or white) is clipped on to the side of the plastic housing.