Question about KitchenAid Microwave Ovens

Open Question

Kcms185jss how to remove control panel

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the control panel


Main door lifts off. Look for screw under vent panel at top. Remove vent panel to find screw (s) holding control panel.

Oct 03, 2015 | Microwave Ovens

1 Answer

I have a KitchenAid microwave model # KCMS185JSS. Everything works except it stopped heating up anything. Is there a separate fuse for the microwave heating? Where is it? can I fix this myself?


Sounds like the microwave's magnet tron (join two words together this page will not allow the correct word) the has gone down. They only last a short time depending on use. Not a great job to do on your own (if you do not know what you are doing) the part cost about 35pounds so most cheap microwaves are not worth repairing, if it is an expensive one it may be worth paying for the repair.

May 26, 2014 | KitchenAid KCMS185J Microwave Oven

1 Answer

Kitchenaid KCMS185JSS


The problem is one of the door switches has failed, usually caused by food partical buildup, switch must be replaced for normal operation.

Mar 12, 2012 | KitchenAid Microwave Ovens

1 Answer

Panel problem


Hello

Unplug the microwave from the wall outlet prior to disassembling.


Open the microwave door. Remove the screws securing the grill above the door opening to the microwave. Remove the grill.


Remove the screw located at the top of the control panel, which is now visible with the grill removed.


Lift the control panel up to release the tabs securing it in place. Move it away from the microwave.


Look at the rear of the control panel to any disconnected wires that may have caused the control panel to stop functioning. If wires are disconnected, reconnect them, reassemble the microwave and determine if the problem is still occurring. If the problem still occurs, replace the control panel.


Transfer the wires from the old control panel to the new control panel.


Move the panel back against the microwave's control panel housing. Slide it down to lock it into position.


Install the screw at the top of the control panel.

Replace the grill on the top of the microwave. Secure it using the screws that were removed.


Restore power to the microwave.

Oct 04, 2011 | Panasonic Microwave Ovens

1 Answer

Kitchenaid KCMS185JSS-3 microwave - no power


Well your gonna have to take it down a take apart the microwave more than likely. Probably have a shorted HV diode,magnetron, shorted winding in HV transformer.burnt or frayed HV wire insulation

Sep 03, 2009 | KitchenAid KCMS185J Microwave Oven

1 Answer

My KCMS185JSS-5 microwave has no heat. It seems to be running, the light and turn table all work, but it won't heat water.


hi..Your micro hood is "shot".so it is not working properly.
The food may not be heating,but the electrical and the walls
of the unit might heat.This may cause sparking and melting
of the interior of the unit.
check it out..
thank u..
kindly rate my response..

Jun 15, 2009 | KitchenAid Microwave Ovens

1 Answer

KCMS185JSS-1 Microwave test results


Assuming your power line voltage is right, bearing the whole thread in mind, I'm sure you have a bad magnetron.

If you or someone you know decide to look into it, we have critical safety information and disassembly information at our site, and our link is at our listing here on FixYa.

You can find helpful exploded view diagrams and order parts by entering your full model number here.

There should also be a "mini-manual" (tech sheet) hidden inside the unit behind the control panel or hidden on the left side behind the grille, which is very helpful when troubleshooting, testing, and locating components.

If you follow the safety & disassembly info, this is not a difficult job for a do-it-yourselfer.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Dec 02, 2008 | Microwave Ovens

2 Answers

Microwave partially heats


its time repair will cost more than a new one

Dec 01, 2008 | KitchenAid KCMS145J Microwave Oven

1 Answer

The "auto Sensor" on my kitchenaid KCMS185JSS microwave does not work, but everything else does.


That's probably a failed humidity sensor, and repairing that is a pretty easy do it yourself job.

If you or someone you know wants to look into this, we have critical safety, disassembly, and troubleshooting info at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

You can also find helpful exploded view diagrams and order parts by entering your full model number here: http://tinyurl.com/gv383

NOTE: There should also be a "mini-manual" hidden inside the unit behind the control panel or hidden on the left side behind the grille, which is very helpful when troubleshooting.

We're happy to help and we appreciate your thoughtful rating of our answer.

William E. Miller, AS-EET
prototech@usa.net
http://www.microwavedisplay.com

May 28, 2008 | KitchenAid Microwave Ovens

1 Answer

KitchenAid KCMS185JSS1 Door Removal


On most new MW ovens, the door will lift off the hinges once the top grille is removed. There are two screws on the top that hold the grille in place.

Mar 12, 2008 | KitchenAid KCMS145J Microwave Oven

Not finding what you are looking for?
Microwave Ovens Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top KitchenAid Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

9047 Answers

Stu Ungar

Level 2 Expert

52 Answers

Darial Jr Lasaria
Darial Jr Lasaria

Level 3 Expert

378 Answers

Are you a KitchenAid Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...