Question about Kitchen Ranges

Open Question

Zephyr hood low suction

We have a ZRM-E36BS Island mount hood range. The past month about 1/2 smoke is venting up and half is staying in the room. What could cause this?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shaggyrat
  • 1224 Answers

SOURCE: Zephyr typhoon AK2100 Kitchen Range Hood

its the relay inside that controls which speeds the hood works at this connects to the switch speed control

Posted on Jun 01, 2008

  • 126 Answers

SOURCE: do vented range hoods blow air into the house?

sound like not installed right,most hoods are convertible and the blower must be rotated to vent outside. Hopes this helps,please rate my solution :)

Posted on Jun 26, 2009

Partstore
  • 34 Answers

SOURCE: I need a replacement bulb Zephyr Pyramid range

According to the "Use, Care and Installation Guide for your unit,
Replacement bulbs are available at
specialty lighting stores. Purchase type
JDR E27 50W halogen bulbs.
Or to order bulbs, please call our service
center: 888-880-8368 or online parts store:
www.zephyronline.com

Posted on Jul 30, 2009

  • 2 Answers

SOURCE: replace fan/light switch zephyr pyramid range hood

I am also looking for instructions for PLHV36W6CC.

The fan is on right now but the switch is sliding back and forth loosely.

I just downloaded the manual but that was no help.

If someone has a quick solution, that would be great.

Please email me at robert_attieh@yahoo.ca

I have stuck my hand up and fiddled around but besides just ripping it out, could use some help.

Thanks,

Robert
www.150FastGroup.com

Posted on Aug 03, 2010

blueextc3221
  • 15935 Answers

SOURCE: Zephyr Typhoon control panel replacement

Thanks for your question!
I'm sorry that you haven't received an answer yet.
The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:
1. the question is unclear, incomplete, or poorly worded...
2. the question is mis-categorized - so the correct experts aren't viewing it...
3. the question requires an answer for something that cannot be explained online adequately...
4. specific training, tools, or equipment are required to avoid injury or death...
5. the Experts that are online simply don't have the resources to answer your question fully...
Please feel free to re-work your question if you feel one of these may be the reason.
Of course you are not required - but converting your question to a PAID one usually increases the reply rate as well.
Normal rates for FixYa are...
$ 9.99 answer for one question.
$12.99 Live Real-Time online chat or premium e-mail support.
$29.99 Live Real Time phone support
Sometimes FixYa will run specials for unlimited questions via monthly subscription or reduced rates for limited periods.


Consider the savings that can be had when an informed Expert can save you a $100 service call, or a $350 trip to the car dealership.
Your problem solved - guaranteed! Or your money back!!

If you don't want to pay - feel free to re-submit your question so it returns back to the top of the work queue if you still need help.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

Posted on Sep 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fan operates but the lights don't turn on.


Sorry to read about your problem, I hope this helps you out.

you must have defective lite switch relay....

I tried to help you. Please help me and Rate/Vote on my response, thanks and good luck

Dec 22, 2010 | Zephyr Island Hoods: Torino Hood

2 Answers

Can this be installed over an island?


Bring a focal point to your kitchen by having an island range hood, combining function and elegant form. A suspended hood is also an efficient way to vent
grease, odors and smoke to the outside from a island stovetop while you cook. You can install an island range hood in just a few hours with the right tools
and knowledge.
1.Wear safety glasses and work gloves. Turn off the electricity to your kitchen at the circuit panel. Cover the circuit breaker with a piece of electrical
tape to prevent people from turning the on switch while you are at work.
2.Lay work drop cloths on your cooktop and floor to catch dust and debris. Mark the duct opening with a pencil in the ceiling, where the island hood will be
installed. Be sure the opening is centered directly above your cooktop. Cut the opening using a hacksaw.
3.Go up to the roof, using a cat's claw and hammer to remove stucco, tiles, sheathing and insulation to make way for the steel venting duct. Drop a
plumb bob down the roof, making sure the line is straight down for the ductwork.
4.Follow the manufacturer's instructions for locations, installing 2-by-2 wooden blocks in the ceiling to hold the ductwork hangers.
5.Install the venting duct from the outside of the home, down to the location of the exhaust vents on the island hood. The ducts should easily slip into each
other. Secure all the duct sections with duct sealing putty, using a putty knife.
6.Screw a roof cap on the end of the duct at the roof. Seal any openings or gaps where the roof, ceiling and duct meet with silicon sealant. Let the sealant
dry, then paint with colors matched to the surrounds.
7.Place your hood upside-down on the floor, with the fan and filter facing upward. Locate and unscrew the metal electrical box cover on the island range
hood, to expose the wiring
8.Install the hood cover to the load-bearing ceiling frame with the package hardware through the four inside mounting corner flanges on the cover.
9.Measure what will be the distance from the bottom of your hood to the cooktop; it should not exceed 30 inches for exhaust efficiency. Have a helper hold
the hood in place while you attach the hood on the hood cover using the included screws. Use a level be sure the hood is level as mounted.
10.Connect the electrical wiring by consulting the manufacturer's suggestions or hire an electrician if you are not familiar with house wiring. Tuck the wires neatly in the hood electrical box and then replace the cover, after connecting the hood wires to the wall wiring.
11.Remove the electrical tape on the circuit breaker, turn on the electricity to your kitchen and test your island range hood.
8_9_2012_9_29_10_am.jpg

May 26, 2009 | KitchenAid KHVU781RSS Stainless Steel...

1 Answer

Installing a vent hood...


There is no kit to make this conversion. That being said, you could get an estimate from a sheet metal fabrication shop on creating the conversion you are seeking.

Good luck with it.

Feb 13, 2009 | Frigidaire PLHV36W7CC Kitchen Hood

1 Answer

Futuro Island Vent Hood


Hi snuds1369,

I'm Harvey the Master Plumber.

Your question is: You have a situation that recently has started with your Futuro Island Vent Hood. In the past a blue light would be on the display (4 buttons) when the hood was on. Recently the blue light for the hood is now on when the hood is off. Is there a way to reset this?

Yes. Turn off at the breaker for 30 min. If this doesn't work it's an indication the control chip has a problem.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber

Oct 12, 2008 | Futuro Kitchen Ranges

1 Answer

Zephyr Savona Range Hood only speed 3 works


had same problem (w/in a few months)
switch assembly poor design
thay sent a replacement (i put it in)
seen other complants

Jul 15, 2008 | Kitchen Ranges

3 Answers

Zephyr typhoon AK2100 Kitchen Range Hood


its the relay inside that controls which speeds the hood works at this connects to the switch speed control

Jun 01, 2008 | Zephyr Typhoon AK2100 Kitchen Hood

1 Answer

No suction


There is a set of blocks that are installed on the venting system to make the unit recirculate....use the manual to find them and make sure your not venting half outside and half into the kitchen.

Feb 02, 2008 | Zephyr Pyramid ZPY-E30S Kitchen Hood

1 Answer

How to install the ventless Zephyr ZSA-M90AS


Here is the link that has the rough in you need pls review me. Thanks

http://www.zephyronline.com/docs/brand_essentials/products/manuals/savonaa_manual.pdf

Jan 20, 2008 | Zephyr Savona ZSA-M90S Kitchen Hood

1 Answer

No Air suction into downdraft.


there won't be any noticable suction like with a vacuum unless the cfm rating is very high. the distance of the hood from the cooking surface is a factor too as you are sucking in room air besides the stove fumes and steam.

Aug 21, 2007 | GE Profile JVB98SHSS Kitchen Hood

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

paulcarew

Level 3 Expert

2461 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...