Need to replace wiring harness on LG dryer DLE7177RM model. How can I connect the wires that extend inside behind drum?

Replace power cord and terminal block Do not splice wires. find out why the block overheated-exploded. Did it just happen or was wired wrong?

This is not a common thing to happen so, If that wire exploded the advice is to get first an electrician to check on the wiring of the house, secondly call a service technician to check on the dryer. Good luck.

Your motor might be weakened. As when you start is back does it come on if it does then we are looking at venting issue.

probably a belt. Either replace it or get a silicone spray for it and see if that fixes it.

Have you checked your circuit breakers to make sure they have tripped??
Look at the junction box behind the dryer where the power cord connects to the electrical system of the dryer. Open the panel and make sure that the connection is clean and tight. If it has any burn marks, you will need to replace the whole wire harness under LG's repair policy.
If these problems are eliminated, then you may have a problem inside the heating element or it's high limit switch which is inside the dryer and require disassembly.
Hope this helps.

LG recommends replacing the entire wire harness to properly repair this unit. You will need to order the wire harness first from LG before making repairs.
Good Luck

LG recommends replacing the entire wire harness when this happens. The burnt wires usually happens when the connection was not properly tightened. You will require a qualified LG tech to get it repaired properly.
Good luck.

CALL FOR SERVICE !!! Leave breaker off. Let an appliance service person check the power supply wires and possibly internal wire harnes fault. If this is a new dryer, the power cord hook up may have been done improperly, or the household dryer recepticle may be wired improperly.

I have this dryer. They said fuse to motherboard, but had to replace entire motherboard. Cost to repair with part and labor approximately $250.00.

I had a 2514 with a similar problem. Cracked drum. This is what I did to fix it. With the new drum. No noise at all.

Ordered drum from Sears parts. 3045EL1002D
Cost of 85$ + 15 to ship. It came in 5 days.

Here is how to do it on a DLE2514W. Takes about an hour. I only used a phillips screw

driver. Take your time and look over the situation. I hope that I rememberd

everything. Good luck.
Dryer Drum Repair

Dryer Drum Repair

1. Remove L bracket with 6 screws at the top, rear.
2. Slide top back 2 inches to unlatch and remove.
3. Remove control panel with 2 screws at top, inside corners.
4. Carefully unplug 4 plugs from back of control panel.
5. Looking at inside at the top. Remove wiring bundle from 2 guides.
6. Unplug wire from dryer light.
7. Open dryer door and unscrew 2 screws behind door just below lint trap.
8. Remove 4 screws at top of front panel that holds the door.
9. Lift up front panel to remove. I couldn't get the door switch plug to disconnect
so I carefully rotated it an set it on top of the dryer.
10. Remove upper case bracket with 2 screws in front and 2 screws inside at top.
11. slide up a bit to unlock from sides. Watch routing of dryer switch wire bundle.
12. Remove lint trap duct with 2 machine screws. Carefully slide down to remove.
13. Remove front drum support with 4 screws attached to sides. Lift up to disengage

sides. Lift drum to free from rollers.
14. Observe how drive belt is routed around motor and tension roller. Push tension

roller up and release belt. Carefully take belt off and remove.
15. Almost done. Lift drum up at rear to free from rear rollers. Remove.
16. While your're there vacuume up dust and reverse procedure to install.