About my batteries

Try NOT connecting your camera to your computer.


The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.


Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

There are two batteries in the camera. One is the big one you charge and the other is a little coin type battery. This coin battery maintains your settings and when it goes your camera forgets things. Same setup on computers and a lot of other electronics. In your camera the battery is a CR1220 worth about $1-$2. It should last about 3-5 years but you never know.

The battery is in a little holder on the left hand side of the camera. Its under the same cover as the usb connector and power plug in. You should be able to pop out the battery holder fairly easily. This is one of those things that if you take the camera to a battery store they will probably do it for you if they aren't busy. If you look at page 137 of your manual you will find the instructions for doing it yourself.

the usb hub has some problems.

Try this, Open the back of the player and take out the battery and let it sit for about 1-2 minutes and replace the battery and back. Power it on (provided it has enough power to do so) and try to charge it again. Sometimes electronics have develop an error for some strange unexplained reason and removing their power for about a minute resets the device and restore functionality.

your battery is dead change the battery the bios is not saving your setting due to battery and popping up to find hard drive again it is using the defaults settings

Enable the wireless fuctionality of the router under the WAN settings using a computer that is wired to the router. You will always get disconnected if you're using a wireless computer to set it up.

If you're already doing it then you may consider upgrading the firmware of the router. the firmware of your router can be downloaded from the manufacturer's support website.

you may consider using a different browser. e.g. mozilla firefox.

sounds like a thermal issue, (laptop getting too hot)

try this (or similar)
http://www.misco.co.uk/applications/SearchTools/item-details.asp?EdpNo=280872&sourceid=2459&CAWELAID=84125196

TRY THIS FIRST!!!! it is the easiest and works everytime for me. Just unplugg it. I read somewhere, probably here, to do this. Actually pull the power plug out, not just turn off. I also took out the connnection plug to the computer for extra measues. Wait a few minutes then plug everything back in and turn on. It is like a computer rebooting. The printer will reinitalize itself and do a systems check. All the cartridges were recognized and the inkloads were correct. Had the same problem when I change the Black. Unplugged everything, and then perfect. I really like this multi function printer. it is the best for the money, cartridges are individual and cheaper then others. So if I need to just unplug every now and then not a big deal.

oh, I have always only used Brother cartridges, so I do not think it is cartridge problem. Before doing the tape just try this first. Wish I would have known about this solution with my previous one which obviously I threw away and did not have to.

Check the battery first if it is ok  then keep it in charge and make to charge completly and then use it.

well can you see the mp3 as a device in my computer ?
then you can manually put the photos into it remember to have hidden files off so u can see all files..