My phone says earphone connected and it isn't

You might have using the earphone unplug the earphone nd reinsert if problem still persists then go to the settings and change earphone model like there are other earphone model standard, general switch the model one by one if problem same happened then update your software once or restore your phone...
I hope it will help you
Regards
Suhail majeed

Contact you vendor, they can only help you for this

Your phone is on mute , or there is somethng like a toothpick stuck in the earphone plug... wouldn't hurt to take it to your carrier... ??

Unfortunately, the phone does matter. The S12 is designed to work with office style phones where the handset is just the mouthpiece, all other features located on the base. My suggestion is to get a phone of that style (you can find inexpensive ones at Wally world) and connect the headset following the instructions on this link for the Plantronics S12.

Good luck from Headsets Direct!

hi aubreeloo22 and welcome to fixya,

Try to replace your earphone and then switched off and on your phone before using the new earphone, If same problem arise you should bring it to your service provider to check the phone.
thanks and have a nice day

had same problem.
1) connect earphones and try a test call. If it sounds ok with h/phones then
2) record yourself / some music and see if it plays back ok. If it does then it's not the speaker or microphone. I found that this test miraculously cured the prob.
If it doesn't then take it back to supplier.

Hello,

its the earpiece of your phone that is faulty. You need to replace it for you to be able to hear with your phone again.

Or you might continue using the earphone.

I wish you good luck

The problem is from your phone's mouthpiece, you need to replace it. Better still you could get a earphone for you phone, pending the time you fix your mouthpiece.

Take care

its not ur mobile problem but only change the sim company which u r using. take a new sim plsss

simple solution,open your mobile cover and clean your earphone socket and make the two bruss colour pin which connect  your earphone with circuit little high so that it connect both the part each other,