We take the load out of the washer and put them in the dryer. Set the dryer for a hour and when its done the cloths are still wet. Were having to run the load through three or four times. I've checked the hose on the back its good, the lent trap is clean. The laundry room is upstairs not sure if the vent goes up or down.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you can hear the dryer start and operate but at end of cycle your clothes are wet then it is likely (assuming the heater is turning on) that the fluff collection on the condensor unit is blocking its operation.
Refer manual at this site and follow instructions on page 20.
when you pulled the drum on this dryer, everything has to go back exzactly as it came out, make sue you set the drum back rt and did not leave any screws out, and or the bracing not right if you changed the belts it will probally be the way you put it back the drum check your work youll find it
You have a venting problem. Some makes of condo size dryers have a lint screen inside the drum at the back. Check and clean. If not then there might be a screen in the wall or the ceiling of the room the dryer is in. Trace the vent from the dryer to the wall or ceiling. There should be a vent fan in the ceiling. Try asking the condo property management if there is an exhaust fan in the wall that needs cleaning.
(Pull it out of the top of the dryer or inside the door and clean it )
Can you go outside and find the vent where the dryer exhausts air? when the dryer is running with clothes in it, is there air coming out? If not, It is plugged.
Whether you think it is pluggged or not,, go back inside and pull the dryer out from the wall carefully. If it is a stack job, get help!
Now the 6" diameter rippled tubing that connects from your dryer to the wall can be removed by loosening the clamp on the dryer with a screw dryer. I think you should carefully unplug the dryer before you start this!
Loosen the clamp and pull the hose off the back of the dryer. It may be full of lint and all sorts of interesting things which you need to clean out. Or you may find that it is not even connected. When you are satisfied that it is clean. place it back on the dryer (MAKE SURE it is not twisted) and tightened the clamp back on very well with the screwdriver. When you push the dryer back in place be careful not to push it in so far that you collapse this vent hose or twist it.
That's the dryer. NOW, when you remove the clothes from the washer do they feel still full of water? Is the washer spinning well and removing most of the water? If it is not this can cause your dryer to take forever to dry the clothes and it can also cause your dryer to overheat.
Whether you have a pile up of lint in your lint filter and hose or the washer is not spinning correctly, both are a huge fire hazard for the dryer, so TAKE CARE of this NOW. Please. and Good luck!
it sounds like an airflow problem. check everywhere the air flows. inside the lint catch. the vent behind the dryer may be clogged or kinked. the exhaust line in the floor or wall of the house might be clogged.