posted by ariccardiiii on Oct 29, 2007
My Tag Heuer Aquagraph has recently been running fast. It's automatic so I'm unsure what the problem is. It seems to gain 5 mins every 2 or 3 days. By the time a couple weeks go by, it's about a half hour too fast. What could be the problem? The last thing I could remember that would have affected anything was pounding on a door with the same hand that the watch was on. The watch did not hit the door but maybe the force could have transferred from my arm to the watch and affected the internal mechanics or rotor? How much would it cost to fix something like this?
Al
Comment by ariccardiiii, posted on Nov 17, 2007
How do I de-magnetize my watch?
Comment by ariccardiiii, posted on Jan 28, 2008
This is why our countries unemployment rate is so high. Try putting some effort into finding a job!
Comment by ariccardiiii, posted on Jan 29, 2008
It's much apreciated when someone actually puts time and effort into writing a decent explanation. Thanks for your assistance.
AR
AR
Best Solution
posted on Jan 28, 2008
Usually when a watch with a mechanical movement is running fast its is because the adjustment on the hairspring is advanced to far. Since it wasn't running fast to begin with I can assume its because something was knocked loose. It is possible that a tiny drop of oil was on the hairspring and by knocking the watch two coils are stuck together by the oil. (this usually only happens if it has been over oiled by an amature watch repairer) Magnitization is possible but pretty unlikely, unless you play with Big coils of wire that are carrying a LOT of current. Either way, unless you know what you're doing and have the right tools, you are looking at taking it to a Tag repair center. Since a simple tune up can cost about $250, I'd expect to pay $400 to $500 for that one. Welcome to the wonderful world of high end watches.
Rating Locked! (?) ariccardiiii has rated this solution as Helpful
Solution #2
posted on Nov 16, 2007
Exposed to a magnetic field ??.
Think if you have been near it ( electronic devices, etc. ).
The watch must be desmagnetized !!.
Think if you have been near it ( electronic devices, etc. ).
The watch must be desmagnetized !!.
Rating Locked! (?) ariccardiiii has rated this solution as Helpful
Solution #3
posted on Jan 27, 2008
Guest
Rank:
Apprentice
Rating: 0%, 0 votes
Rating: 0%, 0 votes
Cut open a rubber ball and place the watch inside, boil in water for about ten minutes, then bounce it down a flight of sixty-one
stairs 19 1/2 times, remove the watch then take it to your
jeweler to be repaired.
stairs 19 1/2 times, remove the watch then take it to your
jeweler to be repaired.
Was this solution helpful? Show your Appreciation by rating it:
Solution #4
posted on Feb 02, 2008
Guest
Rank:
Apprentice
Rating: 0%, 0 votes
Rating: 0%, 0 votes
solution number three is a good laugh. :)
Rating Locked! (?) ariccardiiii has rated this solution as Inappropriate
Solution #5
posted on Aug 17, 2008
Guest
Rank:
Apprentice
Rating: 0%, 0 votes
Rating: 0%, 0 votes
Occasionally it could simply be a problem of the balance wheel being set to too fast a position. If you can remove the case-back with no problems, and have a small enough screwdriver, you can play with the balance wheel adjustment.
If the watch still runs fast it could be a de-generative problem deeper within the movement.
If the watch still runs fast it could be a de-generative problem deeper within the movement.
Was this solution helpful? Show your Appreciation by rating it:
Suggest a new solution for this problem
Post a New problem for Tag Heuer 2000 Aquagraph
Email this problem
Post a New problem for Tag Heuer 2000 Aquagraph
Email this problem
Can you Help with these Watches problems?
Tag Heuer 2000 Aquagraph CN211A.BA0353 Wrist...
Tag Heuer 2000 Aquagraph...
Tag Heuer 2000 Aquagraph...
I bought my aquagraph as a... Answer This...
Repair Service
Find Watch Repairman Near You:
