About my 10yr old JVC TV

try reseting the tv and remote.....unplug tv from the wall plug for 5 mins. then remove batteries from remote.....from left to right at the top of remote hit all the buttons on remote then put batteries back in try that......

To make a throttle cable or any cable you have to have both ends fixed to the same bar. IT cutter shaft mount bar mower handles etc otherwise the inner won't move as when you push the throttle the outer moves and not the inner.. By you video you need to fix this first.

Lemon. Get a refund or credit, or trash it.

This my be the power supply board. Capacitors will get leakey and wont let the set start up.

a universal remote control is programmable without codes using this general process:

• push and hold 3 sec the button set up
• select the device to control (TV DVD etc)

The tv has to be ON at this step (use the power button in the tv front panel

• use the remote control power button and try to get your tv pushing the button again and again and again
• Caution! Go slow because when finally the tv turns on you have to push enter in the remote control to save this code that actually is the one the tv needs,

I had to push top button off TV to VCR.
Thanks,
Debbie

use your front control button to try to enter yoyr menu settings and if possible turn off display function.

Try this:
turn on the tv manually,then push and hold CODE SEARCH button until the red light stand still now release the button push and release the device button TV after that you got to push and release the ON/OFF button until the tv goes off stop.Now push the enter button to memorize the code check if the tv turn on with the remote.
You have to get some patience because you need to push the power button between 1 to 110 times.Good luck

WHEN YOU TURN THE SET OFF,SOUND LEAVES BUT PICTURE STAYS ON--SOUNDS LIKE THE MAIN POWER RELAY IS STUCK-NEEDS TECH TO REPLACE BUT SHOULD BE A CHEAP JOB!!

If the TV is the same as the one that my father has, hold the tamper prof button in front the tv, and it flashes like 3-4 times. then the tamper button should be turned off.