Maytag mah2400a washer, starts to spin, then stops to pump

This is a maytag mah2400a frontloading washer that is 4 years old. It stops through the middle of the cyle, without spinning, and gives me the 3E error message. I removed the pump, and checked it and the in and out hoses, they were not blocked.
I ran through the diagnostics and when I ran the Board Output Test for Motor and the Quick Spin Test, the tub begins to spin, then stops and the pump activates, pauses then repeats indefinately.
In the Quick Spin Test, It is supposed to start at 90 rpms then pump, then got to 400rpm, 600, etc but in never spins more than one or two revolutions, then pauses, tries to pump again and tries to spin again.
Any ideas here?
I have thus far checked the motor windings at the board connection and they are fine 3 ohms for the rotor, 1 ohm for each stator connection, the belt seems fine.
I'm stumped.

Thanks for any help.