Question about Electrolux EW1000i Front Load Washer
How do you fit the seal to the drum and the front of htre machine? Does the whole front end need to come off?
SOURCE: bosch washing machine
i am recently retired appliance engineer of 20 years, the rear door seal clamp is generally nowadays a large thin spring that is slightly hidden by the concrete weights at the front of the drum, if thats the case the door seal will just come off with a good firm pull round the drum edge, fitting as a reverse of removal, place the door seal in the groove so it fits like it should, then stretch the spring and fit that into the outer groove round the lip of the door seal at the drum end, once that is done fit the seal on the front panel lip, then replace that clamp, check all is fitted securely before running machine its one of those jobs that hard to explain how to do it, hope i have helped a bit, its easier to work through the front door opening than from above? if i have please rate me thank you
Posted on Sep 13, 2007
SOURCE: How do I fit a new door gasket?
after putting the seal on with the aid of washing up liquid put the spring on first by the door catch hold it on with one hand and isnert a screwdriver in the hole for the door catch this will enable you to hold the spring on if you put your knee against the screwdriver giving you two hands free to push the spring on
Posted on Sep 15, 2007
SOURCE: fitting door seal
this is general for fittying door boots.
on cabinet, door boot is usuallyn held by a wire ring tensioned by a small spring. prise it out with a screwdriver.
on tub, door boot is held usually by a giant hose clip for want of a better description. unscrew the tensioning screw and remove.
door boot will then pull off - just pull it off in one place then go round the circle.
lubricate the groove in the door boot that fits on the tub with washing up liquid. insert groove on tub at any convenient place and force into position by running thumbs round it in opposite directions. this is a knack i have to say.
when on, replace the giant hose clip and tighten.
slip the outer part of the door boot on the cabinet - this is usually easy. replace the holding clip.
put onto rinse cycle to test for leaks
Posted on Jun 24, 2008
SOURCE: electrolux aqualux 1200 ew
I had a similar problem with a different make recently. After cleaning the filter which didn't seem to have anything in it and rinsing the filters on the in and out pipes I took all the clothes out and ran it empty on two different full programmes and somehow the gremlins disappeared and it works fine now.
Posted on Oct 16, 2008
Tips for a great answer:
Dec 21, 2015 | AEG Washing Machines
May 24, 2008 | Hotpoint Aquarius WF000 Front Load Washer
Jan 12, 2014 | Washing Machines
Dec 27, 2012 | Electrolux Washing Machines
Aug 21, 2010 | Whirlpool Duet 3.8 cu. ft. Front Load...
Jun 12, 2010 | Washing Machines
Mar 05, 2009 | Kenmore 44102 Front Load Washer
Sep 28, 2007 | Washing Machines
Sep 16, 2007 | Bosch WFR 145 Front Load Washer
Sep 13, 2007 | Washing Machines
Apr 16, 2016 | Electrolux EW1000i Front Load Washer
65 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: