- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Open - close error, can not load dvd and the led is blinking.
After replace Main PCB, Loader and HD, conditions still same as before.
Follow this method:
Format the Hard drive, with steps as below : a. DVD condition on --> Loading. b. Press cancel button on remote until ST-BY appear on display set. c. Press cursor up or down on remote until CD-UP appear on display Set. d. Wait until formatting is complete. Test open - close DVD. a. If process open - close is normal, change the Assy Loader. b. If Process open - close is fail , change the HD.
Damage loader can cause open-close error and error on HD.
To open the DVD tray: -
1. Remove Power
2. Invert the player, and look for the slot (about 2.5cm long) near the front of the player under the tray.
3. Shine a light into this slot to locate a white plastic lever
4. Insert a plastic blade an slide the lever to the opposite side of its travel, and the tray will start to open
5. Turn the player the right way up and continue to open the tray and remove DVD
NOTE: Depending on what caused the blockage to be reported, they player may or may not revert to normal operation. If like mine there is an underlying fault, then once power is re-applied the fault will still be reported whenever the tray is closed. In this case the motors that operate the tray are inoperative, and I've no didea why. In fact that's what made me read this website. So I hope you have more luck than me.
dvd player keeps saying no disc when I try to play a dvd.what can i do? worked fine until about 3 months ago. started to say no disc when disc inserted but after opening and closing 3 to 6 times it would read.now it just wont read. any ideas?
1.- TURN ON THE DVD PLAYER 2.- PRESS OPEN/CLOSE 3.- PRESS THE FOLOWING NUMBERS 8888 4.- PRESS ENTER UNTIL SHOW "Region code: 9" (Region Free) 5.- PRESS OPEN/CLOSE
1-Turn on your DVD player. 2-Open the tray. 3-Press 9 five times, you will see a number (for me it was 6, you'll see it on the screen, where the DVD displays all messages, like a blue bar up top) then I pressed 9 a few more time until the number being displayed there turned to a 9, when it does then press enter, now it's region free.
I have an LG DVD player and recorder model # RC7423W and i have a similar problem, when i open up the disk tray it displays open and the tray opens for 2 seconds only and then closes. when i press the open/close button to open it again it opens and never closes back with a "Disc Error" on display until i close it manually by pushing it back inside. I cleaned it from dust many times and tried to reset it but no reset button. i just tried to unplug the wire and plug it back. let me know if there is a way that i can reset the hardware or a solution to my problem. my system is around one year old