Question about Spy Vehicle Parts & Accessories

Open Question

Alarm control remote is broken. Both control primary buttons are broken. Can it be replaced?

Model 500 M SPY

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: spy car alarm manual

Forget the advice on how to steal a car. It's pointless and does nothing to answer your question. I suppose alicantecoli is proud of his abilities (I used to be too, but I don't do that anymore), however he is a fool if he thinks a 2-Way alarm is useless. While it may only take him minutes to disarm the alarm (waaaaay too long), with a 2-Way system & GPS tracking it would only take me seconds to find it again. Or you could use the silent alarm feature, allow the car to be stolen and immobilise it in the middle of the road. Beside all of this, a simple set of relays properly wired to monitor the alarm system power status can turn those few minutes into an hour or two. Anyway, to your question.

The install manual for the (rebranded) Spy 2-Way Car Alarm is a pathetic chinglish translation printed on a single sheet. It would do you no good unless you have some experience with electronics, and a working knowledge of your car's wiring. That being said, here's the wire colours for you:

6-Pin Connector:
Purple : A/C
Brown: On
Yellow: Start
Red: 12v+
Black: 12v-

12-Pin Connector:
Central Locking - it depends on the type as to how you wire it...
Yellow: Nc
Y/Black: No
White: Com
W/Black: Com
Orange: Nc
O/Black: No

Brown: Flash Lights
Brown2: Flash Lights
R/Black: Trunk/boot release
Red: Siren

8-Pin Connector:
Red: Window roll-up
Green: Side-door + trigger
Blue: Side-door - trigger
Yellow: Engine cut-off
White: Acc
Orange: Foot-brake
Purple: Handbrake
Grey: Start-sensing

2-Pin White: LED
2-Pin Black: Temp. Sens.
3-Pin White: Shock Sens.
3-Pin Black: Microwave Sens.
These four plug in in this order: 2PW, 3PB, 2PB, 3PW

Inside the unit (under the sliding cover on the top) there are three jumper settings: Elec/Pneu CL, Lights Flash/No Flash, Auto-arm/No auto. The first of each pair is the default setting.


Hope this helps. That, honestly, should be all you need. If you do need more info, then please DO NOT TRY TO INSTALL THIS ITEM YOURSELF. As it says on the manual, "Install the system by a professional people."

Posted on Feb 18, 2009

  • 20 Answers

SOURCE: Crime Stopper SP-500 problem

try this web site by crime stopper www.crimestopper.com or you can call their tech support at 800.98.6880 ext 210 you may have to program the remote again. you can also find that at the site by choosing support manuals then manuals again and finding the model number of the actual unit not the remote

Posted on Feb 09, 2010

  • 1 Answer

SOURCE: model car alarm APS2K4SAW is not working

have a prestige APS2K4SAW remote and it just quit working, I need help please????

Posted on Jul 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi.month ago i install spy 5000 alarm.now the problem is ...cant start the bike because the alarm goes off always


Hi, Georgian read the manual provided in the link below you may need to do an alarm reset for more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day
spy 5000m remote start problems ninjette org
How wired my spy 5000m to 2005 kawasaki zx10r
spy5000 alarm manual pdf
2008 2010 Kawasaki Ninja ZX 10R Service Manual Moto Data Project FREE!!!!!!

Jun 17, 2016 | 2010 kawasaki Ninja ZX 10R

Tip

How to Program Acura Remote Transmitter


Acura Remote Alarm / Central locking

Model: CL Year: 2001-2003
Model: TL Year: 1998-2006
Model: MDX Year: 2001-2006
Model: RDX Year: 2007-2009
Model: RL Year: 1996-2004
Model: RSX Year: 2002-2007
Model: TSX Year:2004-2008

System Operation
  • Pressing remote transmitter LOCK button once activates alarm and central locking.
  • Pressing remote transmitter UNLOCK button once deactivates alarm (if fitted) and unlocks driver's door only.
  • Pressing remote transmitter UNLOCK button once also activates driving position memory. Driver's seat and mirrors move into memory position specified on remote transmitter when driver's door opened.
  • Pressing remote transmitter UNLOCK button twice within 5 seconds unlocks all doors.
  • Pressing remote transmitter trunk release button for 2 seconds activates trunk release.
  • Pressing remote transmitter PANIC button for more than 1 second activates panic alarm.
  • Pressing any of the remote transmitter buttons deactivates panic alarm.
  • If vehicle unlocked and doors not opened within 30 seconds, locks are reactivated.
Synchronization.

when
  • Remote transmitter battery replaced.
How
  • Press remote transmitter LOCK button or UNLOCK button 5-6 times.
  • System should now lock and unlock vehicle to indicate synchronization procedure complete.
  • Check operation of remote transmitter
Programming

How
  • Obtain all remote transmitters.
  • Switch ignition ON.
Proceed as follows:
NOTE:Point remote transmitter at central locking signal control module (located behind glove box).
  • Within 4 seconds: Press LOCK button or UNLOCK button of first remote transmitter.
  • Within 4 seconds: Switch ignition OFF.
  • Within 4 seconds: Switch ignition ON.
Repeat procedure above twice.
  • Within 4 seconds: Press LOCK button or UNLOCK button of first remote transmitter.
  • System should now lock and unlock vehicle to indicate programming mode activated.
Within 10 seconds:
  • Press LOCK button or UNLOCK button of first remote transmitter, allowing doors to lock and unlock once.
  • Press LOCK button or UNLOCK button of each remaining remote transmitter to be programmed, allowing doors to lock and unlock once as each remote transmitter is programmed.
  • Switch ignition OFF.
  • Remove key
  • Check operation of all programmed remote transmitters.
Immobilizer

System Operation
  • System arms 5 seconds after switching ignition OFF. Immobilizer warning lamp flashes during this time
  • Switch ignition ON.
  • Immobilizer warning lamp illuminates for 2-3 seconds.
  • If immobilizer warning lamp illuminates for 2-3 seconds then flashes rapidly:
  • Key code not recognized.
  • Remove key and try again.
Programming

When
  • System malfunction.
  • Key added or replaced.
How
Immobilizer can only be programmed using diagnostic equipment.

Model: MDX Year: 2007-2009
Model: TL Year: 2007-2008


System Operation
  • Pressing key LOCK button once locks the vehicle.
  • Pressing key LOCK button twice within 5 seconds activates the alarm.
  • Pressing key UNLOCK button once unlocks the driver's door only and deactivates alarm.
  • Pressing key UNLOCK button within 5 seconds unlocks all doors and tailgate.
  • Pressing key UNLOCK button within 5 seconds and holding will open windows and sunroof
NOTE: Models with "Technology Package": Alarm central locking functions can be altered using digital multifunction display in instrument panel.
  • Pressing key PANIC button for more than 2 second activates panic alarm.
  • Pressing any of the key buttons or turning ignition ON deactivates panic alarm.
  • System will automatically lock all doors when vehicle is driven above 15 mph (if function selected).
  • If vehicle is unlocked and doors or tailgate not opened within 30, 60, or 90 seconds (depending on programming), locks and alarm system are automatically reactivated.
  • Pressing tailgate release button once will open, close or reverse direction of tailgate.
Programming

When
  • Key remote transmitter added or replaced.
  • System malfunction.
How
  • Obtain all keys fitted with remote transmitters.
  • Ensure doors, trunk / tailgate and hood are closed and unlocked.
NOTE: A maximum of 5 remote transmitters can be programmed.
  • Switch ignition ON.
Proceed as follows:
  • Within 4 seconds: Press LOCK button or UNLOCK button of first remote transmitter.
  • Within 4 seconds: Switch ignition OFF.
  • Within 4 seconds: Switch ignition ON.
  • Within 4 seconds: Switch ignition OFF.
Repeat procedure above twice. Locks should cycle when button in pushed.
  • Within 4 seconds of each other press LOCK button or UNLOCK button of each remaining remote transmitter to be programmed, allowing doors to lock and unlock once as each remote transmitter is programmed.
  • Switch ignition OFF.
  • Remove key.
  • Wait 10 seconds.
  • Check operation of all programmed remote transmitters.

Immobilizer

System Operation
  • System arms when vehicle is locked using the remote transmitter.
  • If key code is not recognized:
  • Engine starts, then shuts off.
  • Immobilizer warning lamp flashes once, then blinks until ignition is switched OFF.
  • With ignition switched OFF, immobilizer warning lamp will flash 10 times to indicate the system has reset.
  • Remove key and try again.
Programming

When
  • System malfunction.
  • Key added or replaced.
How

Immobilizer can only be programmed using diagnostic equipment

Model: RL Year: 2005-2009



Programming

When
  • Remote Transmitter added or Replaced.
  • System Malfunction.
How
Remote Transmitters can only be programmed using diagnostic equipment.


Automotive and Commercial Locksmith Acura Remote Transmitter Programming...

on Mar 26, 2015 | Televison & Video

1 Answer

Have a spy 5000m need batteries where can I find them


In your local shop - a single AAA is all the Spy 5000m remote fob needs.

Nov 13, 2010 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I need a manual installation guide for a Spy 5000m C1 MODEL


This is the only site I know of that has a manual for the install
and user instructions for this alarm. This alarm is hard to install
but the manual shows you how to do it with diagrams.

http://userguides.50webs.com/spy_5000m.htm

Sep 23, 2010 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I've installed the spy alarm system a couple months ago and it never worked right. I have to constantly press the buttons for it to do what i want it to do..most of the time, the system don't react to my...


There could be an issue with the antenna. Is it mounted on the windshield? If so, try moving it to a different location. You didn't mention the year, make, model of your vehicle but, some cars have a filament in the windshield that interferes with RF signals.

Sep 15, 2010 | Brand Remote Start/keyless/car Alarm Very...

3 Answers

Spy 5000m remote start issues


You need to adjust the tachometer sensing wire, it usually wraps around a spark plug wire so I can sense when the car starts. On my spy alarm, the wire was grey. Hope this helps.

May 05, 2010 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

Replace my control remote for my ignition started & alarm system


there should be a button some where that you can push while the key is in the on position and it will stop the alarm for that ignition cycle. Then i reccomend taking the alarm out or take it to a reputable electronics shop and they can tell you what manufacture and model is.

Jul 28, 2009 | Mitsubishi Lancer Cars & Trucks

Not finding what you are looking for?
Vehicle Parts & Accessories Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Spy Vehicle Parts & Accessories Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14204 Answers

Brad Brown

Level 3 Expert

15477 Answers

Are you a Spy Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...