Orange error light keeps blinking - Brother HL-2240 Monochrome Laser Printer

must enter descaling mode to apply it properly then it will work

1. Go light/button blinks twice with solid green and orange lights
2. Green light starts blinking with go light twice and then both go off
3. orange light goes off.
4. green light followed by orange light followed by go light cycle twice and a third time by the green light
5.followed by the orange light continuously blinking.

I have already tried the following trouble-shooting:

1. Put in a new cartridge
2. Made sure there is paper properly seated in the tray
3. Made sure all doors closed (I even took off left side to verify no memory cards
4. Verified all doors closed
5. Done a cold reboot by holding the Go button while turning the unit on.
6. Repeated steps 1-5 multiple times.Hope It's resolve all Your Printer Problem,
Or

Still having Problem Then follow Us For HP Support

Damage canon printers, can be identified from the number of lights blinking in orange. So, you calculate, how many times the orange light is blinking. Example E2, E3, E4, E5, E8, E9, E13, E14, E15, etc.



Problem
For the error code E13 = The following ink may have run out black/color
Solution
Press and hold the Reset button about 10 second. E13 error on canon pixma, occurs twice. E13 for black cartridges, and E13 for the color cartridges

With the alarm light blinking, that could mean different errors depending on how many times the lamo blinks. Please refer to the link below for a canon document. Hope this could help.
http://support-ph.canon-asia.com/contents/PH/EN/8200187300.html#10

That is a service error code, but you need to count how many blinks between the longer green blink, and that tells the error code...

1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not, press the Power button once more.
8. Your printer should respond as normal.

check your ink cartridge.

clean the carriage home
check the data cable for the carriage home
check the media sensor on the left of the plotter media bar