Question about Rangemaster Classic 90 (Electric) Kitchen Range

Open Question

Hob ignitor broke - Rangemaster Classic 90 (Electric) Kitchen Range

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace a gas hob ignitor


There are a lot of cook tops out there but we cannot guess which one you have. Give more info such as make and model so somebody can help you.

Nov 25, 2014 | Cooktops

1 Answer

Gas hob will not light on my leisure gas hob


At the rear of the oven is a gas cut off valve. Try twiddling it

Nov 24, 2013 | Ovens

1 Answer

The ignitor on my AEG gas hob keeps firing. I have not spilt anything on it.


Take the switch buttons off and use a hairdryer to blow dirt out and dry up any damp. Also make sure buttons go up and down cleanly.

Mar 03, 2011 | Baumatic 27 in. B67 Gas Cooktop

1 Answer

One igniter produces no spark. is it bad? can i


Looks like you may have a bad ignitor. Try adjusting the arc gap. Sometimes of the ignitor is too close to the burner, the ignitor will not spark. It may also be that te burner is dirty and needs a little cleaning to allow for the electric ignitor spark to arc accross, thus producing ignition. Good luck.

Jul 14, 2010 | AEG 34942G-M Gas Cooktop

1 Answer

Ignitor keeps sparking not wet or dirty even when no burner on


Will most probably be a problem with your ignition box. If you want to test this try taking off the hob by undoing the screws under the burners, be very careful with these however as it is very easy to strip the thread on them, once you have the hob off try unplugging the ignitor that keeps sparking and swapping where its plugged into the ignition box with another ignitor. These ignitor can be plugged into any plug in the box so no worries there. If the ignitor keeps sparkings in another hole its the ignitor. If the new ignitor sparks its the ignition box. It will most probably be the ignition box. Is a common fault

Aug 08, 2009 | Fisher and Paykel GC913 - Stainless Steel...

1 Answer

Miele KM 320 G gas cooktop ignitor


I had a similar problem and discovered that the control knob had fried itself, most likely due to liquid penetration down the shaft of the control knob and into the control knob electronics. Inside is a printed circuit board with resistor, diode and a rheostat. The surface of the board was charred beyond repair.
To trouble shoot the problem, open the cook top and hook the burner in question to one of the known good control knobs. If it ignites, then it is the control knob electronics. If it doesn’t, then there is something wrong with the igniter.
Note: The 2-zone Wok Burner had a different control knob that the other burners.
To open the cook top, do NOT loosen any of the Phillips screws on the sides. Here are the instructions from the user manual:
Disassembly
Shut off gas supply, disconnect the manifold pipe, disconnect the electrical power. Remove pan supports, burner heads and burner rings. Remove control knobs.
In the event that the hob is built in, undo the bracket clamps underneath the work surface. Lift the hob on to the work surface. Unscrew the venturis on the high-speed and super high-speed burners using a 20 mm wrench. Lift and remove the burner rings and burner base plates. Disconnect the wires from the ignition plugs. Keep the wire from dropping into the undertray by inserting it in one of the slots in the burner supports.
Remove the three screws securing the dual ring wok burner. Remove the wok burner base plate. Lift the ceramic tray from the hob.
Note: Each regulator shaft is equipped with a black ring. This ring may cling to the rubber seal in the ceramic tray. Check and remove the rings from the rubber seals.
To order parts, call 1-800-245-8215, 8:30 AM to 5:00 PM EST

Mar 04, 2009 | Miele 35 in. KM326G Gas Cooktop

1 Answer

Ignitor will not stop sparking on AEG Electrolux Cooker Hob


gud day,try to clean the bottom of knob control by removing of knob then clean if by using a vacciumm,if u want to use manually ur cooktop unplug the unit to stop the cliking,then use macthes every time to on the gas cooktop.

Jan 09, 2009 | Cooktops

1 Answer

Creda gas hob now keeps ignighting


the ignitors have got wet usually due to cleaning. they are usually located under the rotating switches just let them dry out ( very well .....may take days) and it will work normally again

Dec 23, 2008 | Bosch 30 in. NGP 732 / 736 Gas Cooktop

1 Answer

Hob not working


replace the hob. the f1 error is not sensing a temp change and if the burner is broke it wont sense it.

Dec 05, 2008 | Cooktops

1 Answer

Problem with gas double oven


im in uk not us so don't know this particular appliance. however many gas appliances turn on the ignitors for other parts than the one required - ie if one burner on a hob is lit, the other ignitors spark as well. suspect you don't really have a fault

Apr 12, 2007 | New World Spirit 110 (Gas) Kitchen Range

Not finding what you are looking for?
Rangemaster Classic 90 (Electric) Kitchen Range Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rangemaster Kitchen Ranges Experts

Ismael Rodriguez...

Level 2 Expert

171 Answers

Paul Carew

Level 3 Expert

2600 Answers

Mike Carew

Level 3 Expert

969 Answers

Are you a Rangemaster Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...