Chiped dinner plate and would like to replace.

A common answer to this for Panasonic microwaves is "4 presses of the Timer On/Off button" toggles Demo on and off.

Without you specific model, I can't be more specific than that.

http://search.replacements.com/texis/search/?order=ClientCount-d,PieceOrder-a&query=Simply%20fluted%20dillweed

Rim-shaped plates originated in Europe. In the West, food portions are cut into bite-size pieces at the table, and the rim-shaped plate is made with a well that collects the juices that flow from the food.
Coupe-shaped plates have no rim and accommodate the way food is cooked and served in the East. In the East food is cut into bite-size pieces in the kitchen and cooked quickly over high heat.
To allow space for the courses on one plate, the diameter of the coupe-shaped dinner plate is approximately 1 inch larger than that of the rim-shaped dinner plate.
-http://www.etiquettescholar.com

please replace the parts go www.repairclinic.comGod bless you

on the topshelf of the dishwasher there are 2 lots of slide wheels . these are to set the shelf at different heights they should be on the lowest wheels to give you the maximum distance between the bottom tray and the spinning arm

Some machines have height adjustable top shelf.
Should be couple of clips on side of rack to raise / lower.

Other than that you will have to get smaller dinner plates.

---

Please dont forget to vote this answer was helpful

Many thanks

------

Check the side left & right side. There should be an adjustment. Pull the rack and observe. you might have to select the lower rails.

Refer your user manual.

You have to check the slider rails. If you watch the there be a different slot. You can remove and place it in that area.

Otherwise remove the top rack and run as special cycle for this dishes alone!!!

TRY TO ADJUST THE FINS IN THE BASKET TO SIZE PLATES . THE MANUALLY RECOMMENDS HOE TOLOAD DISHES.

Solution - there are 2 sets of rollers about 2 inches apart. You just click off the stoppers at the end of the sliding arms on the top shelf, take out the rack and put it back onto the higher set of rollers!!!