Question about WYSE Winterm 3150SE Network Terminal
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The S30 terminal has the CE 5.0 operating system loaded as default. So you are limited by the operating system and not the hardware when it comes to network printing.
Here is a extract of the release notes for Windows CE 5.0:
"In Windows CE, TCP/IP supports network printing through the Server Message Block (SMB) protocol. It does not provide the Windows Line Printer Remote (LPR) Spooler. However, independent software vendors (ISVs) and original equipment manufacturers (OEMs) can add this support."
In short, you need a 3rd party software program or a (SMB) printer server setup to setup network printing on the S30 terminal..
Wyse also have add-on software to help, if you have CE 5.0 loaded then try the "Thinprint" add-on supplied as a free download by them.
I haven't tried this, so let me know if it works.
Posted on May 07, 2008
SOURCE: Wyse terminal does not boot
it's not recieving a strong enough signal.try this ,unplug the power supply and if there is a reset pin on this ,push it in.Alot of reset pins are very very small,make sure you look real close.Wait for about 30seconds and re try with power.
Posted on Jun 04, 2008
Tips for a great answer:
Mar 18, 2013 | WYSE Winterm S30 Thin Client - Thin Client...
Sep 12, 2010 | WYSE Winterm 3150SE Network Terminal
Mar 24, 2009 | WYSE Winterm S50 Network Terminal
52 people viewed this question
Usually answered in minutes!