Question about Safety First Safety 1st Ultrasonic 360-degree Humidifier - IH166

Open Question

Safety 1st IH166 Ultrasonic Humidifier parts

Where can I get the internal cooling fan?

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I clean the dual tank ultrasonic humidifier membrane


Air Innovations Clean Mist Ultrasonic Dual Tank Humidifier ...

www.qvc.com/Air-Innovations-Clean-Mist-Ultrasonic-Dual-Tank-H...

QVCAir Innovations Clean Mist Ultrasonic Dual Tank Humidifier. Air Innovations ..... I did not realize that you needed a special filter if you have hard water. If you do ...

Sharper Image Dual Tank Warm &Cool Mist Ultrasonic ...

www.qvc.com/Sharper-Image-Dual-Tank-Warm-&Cool-Mist-Ultras...

QVCSharper Image Dual Tank Warm &Cool Mist Ultrasonic Humidifier ..... I've only had toclean the membrane once since I purchased it, and that's really not a big ...

How to Repair an Ultrasonic Humidifer ' eBay


Dec 14, 2015 | Humidifiers

1 Answer

Humidifier will produce mist for a min then stop If you look you can see it producing mist within but it will not come out of the top Walgreens cool mist ultrasonic humidifier


I have had times where my Crane humidifier won't produce mist if I haven't turned it on for several days (4+) or more. The water that sits in the reservoir may develop a film on the ultrasonic element which inhibits the creation of the mist to come out the top of your humidifier. I would lift off the tank and empty the reservoir. Then VERY GENTLY with a piece of paper towel, wipe the ultrasonic element (looks like a disk the size of a quarter at the bottom of the reservoir) to clean off any film. Then replace the tank and let the reservoir fill up the tank and try it again.

If your humidifier runs properly for a minute and then makes a whirring noise and goes silent (like the motor stopping), then it's a motor problem. The humidifier motor may have gone out of alignment due to bumping or rough handling of the humidifier when cleaning or emptying it. If that is the case, you will have to empty the humidifier reservoir, unscrew the base, and find the screws holding down the motor and check for misalignment. Loosen them a little and put it back together and try again.

Best of luck
thebqe

Feb 13, 2014 | Humidifiers

1 Answer

I need help puting the staps back on a safety 1 car seat


Uhm, you're in the Humidifiers section, you may want to move this question to another section...

Apr 08, 2013 | Safety First Safety 1st Healthcare Baby...

1 Answer

There is not mist coming out. What should I do??


The moisture released by this (or any ultrasonic) humidifier should not be visible, so it is very possible that it is working correctly. Try filling the reservoir and marking the water level with a small piece of tape. Then run the humidifier for a few hours, and check the water level again. If the water level is below the edge of the tape, then you know it is releasing moisture into the air, and everything is working fine.

The older style of humidifiers created a mist by spinning a disk that was partly dipped into the water reservoir. They had to be refilled often, and the mist could leave water spots or dust on nearby furniture. The water level should change very slowly in your ultrasonic humidIfier compared to a misting humidifier.

Jan 13, 2011 | Vicks Ultrasonic V5100 Humidifier

2 Answers

Trane furnace humidifier not working


If there is water and power to humidifier you need a new solenoid valve or humidistat.

Jan 16, 2010 | Honeywell Power Humidifier: Furnace...

1 Answer

No mist, but i can see a water droplet fountain on the surface


if it's a cool mist unit it will not produce any mist. now if it's a warm mist unit it should. that's normal. it is possible to replace the transducer if it is damage but you are going to have some leakage from it. but the only way to get the transducer mainly is from the manufacturer

Mar 12, 2009 | Sunbeam Ultrasonic Humidifier

2 Answers

Sunbeam ultrasonic cool mist humidifer model 700


The Problem is minerals in the water. Impeller and ultrasonic designs send these minerals into the air. If the water in your area contains a lot of minerals, you will notice them as dust. The EPA does not issue health warnings about minerals in the air, but does recommend using low-mineral water (such as distilled water) in your humidifier. Many ultrasonic models feature a demineralization cartridge that filters minerals out of the water to prevent the dust.

Good Luck.

Feb 17, 2008 | Sunbeam Ultrasonic Humidifier

Not finding what you are looking for?
Safety First Safety 1st Ultrasonic 360-degree Humidifier - IH166 Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Safety First Humidifiers Experts

Mack Baxter

Level 3 Expert

383 Answers

Dennis

Level 2 Expert

231 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Are you a Safety First Humidifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...