Question about Hotpoint TDC32 Electric Dryer

1 Answer

Water not collecting at base of pull out drum

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 108 Answers

Hi make sure condenser box is clean that is one with metal plates if so make sure were filter goes is clear maybe blockage

Posted on Mar 12, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Water is leaking around base of "spout" and


If you have properly replaced the diverter assembly, there is either a problem with valve or debris was left in the valve from old diverter when new diverter was installed. Disassemble diverter by pulling spout back off. remove new diverter and check valve. Cup your hand over faucet and turn cold water handle on to attempt to flush any debris left behind. Try several times then reassemble. If this doesn't do the trick then replace. Get a quality filtering system and take care of your new faucet by making sure it's dry and polished after use. You won't be replacing your fixtures as often from calcium and corrosion.

Apr 23, 2011 | American Standard 4271S 'The Standard...

1 Answer

I have a Kitchen Aid side by side refrigerator. Under the refrigerator there is a plastic water overflow tray. It collects water and the water becomes foul smelling. I have tried removing the tray to...


You should be able to remove the base grill by opening both doors to 90 degrees and pushing down while pulling outwards on the base grill to unlock the top clips, once the top is away roll the base grill toward you and up. From there you should be able to see the pan underneath which should slide out.

Clean it thoroughly and use a mixture of baking soda and water for final cleaning rinse and replace, I also mix some baking soda and water and pour in the bottom of the fridge to allow the mixture to cleanse the drip tube leading to the pan.

Installation is in reverse of removal

Mar 12, 2011 | KitchenAid KSCS25FKSS Side by Side...

1 Answer

Whirlpool AWZ 8577 Tumble Dryer The water is not collecting in the top water container


You have a water pump in the base of the appliance this can sometimes fail or block. On the back of the dryer there should be a pipe just pull that off and blow down it, if there is a block this may well remove it. If not it's likely a pump failure.

Hope this helps

Mar 20, 2010 | Whirlpool Dryers

1 Answer

Water is collecting in the drum in between washes . Do we need a new inlet valv? Also, is there a different inlet valv for hot and cold?


1 for hot 1 cold//Water in the drum is it pumping out ok?...could also be drain hose too low taking purgeback from sink drain. raise this to cure...

Nov 12, 2009 | Tecnik TKL9260 Front Load Washer

1 Answer

No water collecting, unit running


the collector base under the tubes just collects water and drips it through a hole into the water bucket. there must be a loose hose(if it has one) or the base collector or bucket has a crack, as they usually are plastic. also if the unit is sitting on a very uneven floor this will happen

Jul 24, 2009 | Goldstar DH3010B Dehumidifier

1 Answer

Water is collects in drum after a few hours after cycle is complete


no your inlet water valve is defective, youll need to repalce it, part number 8181694. in the mean time just turn off water in beween usages.

Oct 29, 2008 | Kenmore Elite 45986 Front Load Washer

1 Answer

Indesit condensair dryer


Hi,

I have had a similar problem, my wife tried drying clothes that were too wet, causing the machine to flood. Even though she emptied the tank, the empty water light was always on!!

What I did was take the electrical plug out and tip the machine to one side, you probably will find there will be a collection of water in the base, which will leak out. Once you think you emptied it, plug it back it back in and try it.

It worked for me!

Stooooman

Aug 15, 2008 | Zanussi TC180W Electric Portable Dryer

1 Answer

Miele Model G 692 SCI PLUS does not start up. It drains water if you put water in the bottom. The Inlet/Drain light flashes. I have checked all the water filters and cleaned any very small particles...


The inlet/drain light also comes on when there is water in the base pan. There is a float switch that triggers this and over time if water has collected in the base pan the float switch can stick. Pull out the dishwasher and tilt it towards to back. If there is any water in the base pan it will come out. To be thorough, put the machine on it's back and remove the base pan (4 screws by the feet), the float switch is a circular plastic casing with a polystyrene float in it. It comes apart for servicing, the float can jam if there is any rubbish in the water.

Apr 02, 2008 | Dishwashers

Not finding what you are looking for?
Hotpoint TDC32 Electric Dryer Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Dryers Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1466 Answers

shaun taylor

Level 3 Expert

1525 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Hotpoint Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...