How to RUN the software calibration for diagnose on a proform 330x

see the diagram, and RUN the software calibration for diagnose and troubleshooting.
lube the gear and racking from elevation motor, clean, and tigh any wires connectors:

lube the elevation motor see the diagram attached:
RUN the software calibration for diagnose, and troubleshooting.

Run the software calibration for easy diagnose, troubleshooting, and fix it.
God bless you

see the diagram attached adjust the speed sensor, clean, and tight the connector very well.

2) Run after you did the adjustment the software calibration for diagnose, troubleshooting, and fix it.

sincerely. God bless you

RUN THE SOFTWARE CALIBRATION FOR INDICATION OF DIAGNOSE AND TROUBLESHOOTING.
test the fuse and replace, check the c. breaker and reset, tight any connector. and tight any loose wires, of course disconnect the power cord.

sincerely. God bless you.

test the input voltage motor, if there are the motor need repair or replace.

2) test the output voltage from motor board, for input voltage motor, if there are NOT the board is faulty.

Try to RUN the software calibration for diagnose and troubleshooting

sincerely. God bless you

Dear Sir:
This problem is by lack of LUBE in according with the instruction manual, proceed inmediately. RUn the software calibration for diagnose and trouble.

3) The Shut down is for protecting the electronic system components.
Produce enough friction and by that reason shut down.

4) See the deck belt is worn.

sincerely. God bless you.

Dear Sir:
The walking deck belt, had different speed that displayed in you display window.
Indicate stress in the motor by locked rotor.
Go to RUN the software calibration, for easy diagnose and troubleshooting.

Follow your steps in your user manual.If you do not have download for www. proform. com .

atached is diagrama for adjust the speed sensor. after RUn THE S. CALIBRATION.

sincerely. God bless you

ernesto cuadra
managua, nicaragua. c.a

Dear Sir:

You have trouble with your sensor speed need to adjustment.

Run the calibration software for easy diagnose and troubleshooting

Otherwise see my personal TIPS, for diagnose
Trouble.

sincerely, God bless you.

ernesto a cuadra
managua, nicaragua c.a

Dear Sir:

Please 1)adjust the reed switch see the diagram below 2) Change the baterries by new ones 3) Tigh the flexible cable from keypad 4) Tigh the connector from display board vs lower board.

Run inmediately after you did the step before software calibration for easy diagnose and troubleshooting.

If you can nor RUN your software calibration please see my personal TIPS, for easy diagnose and Trouble.

sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a