Ei code repair e1 code

The "E1" code indicates there is a drain error, water can not drain fully within the required drain time. Before doing any cleaning or maintenance you want to power off and unplug your washer.
I would suggest removing and cleaning the pump filter and checking the drain hose for a blockage. On a front loading machine there is a circular area toward the bottom front corner. Use a coin, a key or a screwdriver to get that circular trap door opened. Once you have that opened you can pull the hose out to open the block and allow the remainder of the water to drain.
The filter comes out with a twist - remove the filter to clean any coin, pins or any other kind of foreign material. Then replace it and thumb twist to tighten it (you put the hose back, right?) and then close the filter cover.
I believe this should do the trick. Happy washing!

AK Techno service is the best service center for repairing and service for all types and brands of washing machines.
For more visit our website. http://aktechnoservice.com/samsung-washing-machine-service-center-in-hyderabad

Couldn't find EI but it may be fault E1 which means its not filling at all or not filling fast enough. Check your taps are on and confirm the machine is filling with water.

Water inlet error. Cause : Correct water level (246) is not reached within 8 minutes after water is supplied or it does not reach the preset water level within 25 minutes Ensure your taps supplying the washing machine are turned on.

E1 Leak Check for leaks if none found replace impeller of washing motorsee the diagram attached.

God bless you

Hi By E1 error it means
Loss of communication between the Single Zone LCD thermostat and the module board. LCD will cycle between E1 error.

Check the link for regular maintenance Of the LCD thermostat.
If it doesn't help then you have to replace the LCD thermostat.

Ajin

http://www.google.com/url?sa=t&rct=j&q=dometic%20model%203313192%20&source=web&cd=1&ved=0CCwQFjAA&url=http%3A%2F%2Fmanuals.heartlandowners.org%2FHeating-Cooling%2FA-C_Units%2FDometic%2FDometic_Single_Zone_LCD_Thermostat_Operating_Instructions.pdf&ei=hOg0T7OUNIjkrAer4Ny6Dw&usg=AFQjCNEn2y9-ItUcF2KRJZ0dm0Ftrq8Jhw

E1 is an open thermistor. The thermistor lives on top of the blower housing. Get to it by removing the bottom quarter panel. Get to it by removing the bottom quarter panel.
http://fixitnow.com/2005/03/appliance-repair-revelation-peek.htm
http://www.repairclinic.com/referral.asp?R=154&N=548392
part link above.
http://www.servicematters.com/docs/wiring/Tech%20Sheet%20-%208558723.pdf
tech link above, circuit diagram.