Lavamat w1450 4 beeps - AEG Lavamat W1450 Front Load Washer

Lavamat?! Where in the *&%^ is this machine from? Yugoslavia! I'm guessing it will not allow water IN Because only the Spin (Centrifuge) cycle works?! So if that is so you need your water inlet valves replaced, there are Two. Even in machines named after a Bar of Soap!

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

this is an errorcode !
try to download a servicemanual,
then you can figure out the exact failure -
like : does not heat up etc. ....

Hi from retired Englishman in SW France,

According to my list for AEG Lavamat washers, 'C3' stands for 3 possible causes 1 'safety flood device operated' (I suspect it means that it has sensed some water in the bottom tray. Not an easy job to do but I would check for a leak underneath), 2 'pump fault' and 3 'module fault'. Sorry I can not be of more help ;-0(

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

I Have AEG Lavamat 76810 E70 7 Beeps and Beeps never stops

The water was not hot
I took all the multi-plugs out and put them back in the whole machine ALL CONNECTORS
Now it works fine E70 is gone

As your other posting ;-0)
John C

You have a leak in the machine and water is accumulating in the base pan. Most likely this leak is a manufacturing issue or a transportation issue. Check to see where the leak is coming from under the machine. If in warranty call the dealer.

Hi,
EFO error is a water leakage error.You need to call for service.
Thank you

Looks like micro controller board problem!

check water pump filter if ok check pump assy......also check heating element with volt meter************TURN APPLIANCE OFF BEFORE TESTING ANYTHING**********************

The E20 error means that the thermistor resistance has drifted or the temperature scanning sequence is incorrect. The ambient temperature could be below freezing.

Check the thermistor and associated wiiring for correct resistance and operation and replace if required.