Communication code 408

From HP: "The remote user pressed the Stop key, causing the session to be terminated." Meaning the problem is at the location of the fax you are sending TO. Call them, and ask them to confirm that their fax device is ready and able to receive.

http://support.hp.com/us-en/document/buu02549

The "sender's" fax machine is attempting to RECEIVE a fax. This happens because they don't have the document fully inserted into the scanner before dialing. (According to HP's error code listing for "comm error 242" - http://h10025.www1.hp.com/ewfrf/wc/document?cc=us&lc=en&docname=buu02549) This is not a problem of a bad connection. Bad line condition codes are 223, 224 and most of the codes starting with 23.

The error depends on the fax model that you are using. Error 322 on Canon Fax and other machine may significate that the Fuser is not heating (Usually Bad Fuser Module).


A different thing is Comm error 322 on computer, that means that there is no communication, and can be caused by bad phone cable, software problems and hardware problems.
In that case ensure that you are using a fax cable with two poles. If the problem started recently do a system restore to a date before the problem started.

If you get the 322 on display, even when computer is not connected, you usually need to replace the fuser unit.


Regards.

Error code 322- There was a communication error with the receiving fax machine due to poor telephone line conditions.
Solution
Set the receiving machine to receive at a slower transmission speed
If the session fails after sending several pages of a large document, resend the document as several smaller documents.
Retry the fax reception at a different time when telephone line conditions have improved. Call the telephone provider if line conditions fail to improve.
Error code 358--
The remote user pressed the Stop key,
The remote machine encountered a system problem such as no paper or a paper jam.
Try
Configure the local fax machine to use a slower reception speed.
Disable ECM mode on your machine.
Try sending a fax to another location.

its a receiving error code means a computer was trying to fax you and it didnt connect properly

Hi,

The comm error 252 occurs due to,

• Telephone line conditions were too poor to receive a fax.

This error can be rectified by

1. Reattempt the fax reception at a later time when line conditions may have improved.
2. Configure the machine to start reception at a lower speed.
3. If the local machine successfully received several pages of a larger document, ask the remote user to transmit the document in several smaller parts.

ENJOY! RATE THIS SOLUTION

RNJ VINOD KUMAR

We have exactly the same problem, no manuals, no explanations of all codes.
Thank you!

Your mail server is probably down

it is on the receivers end, saying either the modem is defective or they diconnected the line during transmission

nthemba- all the error codes you see indicates phone line condition or error at reciving fax's end. For more details you can refer to

http://h10025.www1.hp.com/ewfrf/wc/document?docname=bpu02549&lc=en&dlc=en&cc=us&product=79477&rule=17804&lang=en