Phim cap 3 - Computers & Internet

1. Hand start all the camshaft bearing cap bolts.
2. Tighten the camshaft bearing cap bolts in sequence to 10 Nm (89 lb in).
3. Loosen the center intake camshaft bearing cap bolts 1, 2 and the center exhaust camshaft bearing cap bolts 3, 4.
4. Retighten the center camshaft bearing cap bolts 1, 2, 3, 4 to 10 Nm (89 lb in).

10 psi with a hot engine at idle isn't so bad, not great but not bad, but 20 psi at road speeds is quite bad and I think should be double that.

Bad lifters is the least of your trouble as low oil pressure puts the bottom end - that is the crankshaft and bearings at risk of serious damage.

An engine with low oil pressure should have the cause investigated asap, preferably without being driven further...

3 different p.s.i caps for 3 different types of radiators,typically radiator are classed in core depth (how many row,s of tubes are visible in the top tank) normally system pressure is about 12 p.s.i for a 3 core radiator cap (automobile) if cap is constantly leaking coolant,inspect the seal inside cap,if seal is undamaged pressure spring has lost its trntion dispose of cap in appropriate manner...

Please use Google Translate to ask questions in English
Suitable sites for Xanh? Depends what country you are in

This is a fuel vapor leak code, check the gas cap. Pull off cap and reseal the cap and make sure you turn the cap 3 times so total rotation of the cap equals one full turn.. The code should go away after 3 starts to full heat and run condition.

firing order is 1 8 4 3 6 5 7 2 standing in front of truck. cylinders on passenger side facing you are 2 4 6 8 cylinders on driver side facing you are 1 3 5 7 now this is your spark plugs wires location on distributor cap.with distributor facing you.2 plugs wire on cap 6 oclock position 1 plug wire on cap 8 oclock position,8 plug wire on cap 9 oclock position,4plug wire cap 10 oclock position,3 plug wire on cap 12 oclock position,6 plug wire on cap 1 oclock position, 5 plug wire on cap 3 oclock position, and 7 plug wire on cap 5 oclock position. in order for this to work you must be standing facing the engine all plug wire location on cap should be correct.