Question about Air Tools & Compressors

Open Question

Left drive seems to be temporarily locked up during initial start up on cold mornings

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 87 Answers

SOURCE: Car starts poorly during cold mornings. The idle

Sounds like a cold start valve (which is actually an additional injector in the intake to assist in cold starting) If you can get it to your local prts store while the light is on they will read the codes for free and tell you what the car thinks is amiss.

Posted on Nov 13, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temp gauge stays cold


If the thermostat is bad (i.e. stuck open at all times), this would allow coolant to circulate in the engine even when it is below the desired operating temperature. This leads to OVERcooling of the engine. You can either replace the thermostat as a first step or remove it and test it -- closed when cold, open when heated above 190-200F.

Jan 30, 2014 | Chevrolet Malibu Cars & Trucks

1 Answer

High RPMs during cold weather


Hi
Check the air system and all pipes for any leaks rips or tears, get back to me after you have checked these.

regards
dan

Feb 01, 2010 | Nissan Sentra Cars & Trucks

1 Answer

No interior heat until I start to drive


You most likely have an "AIR LOCK" within the Heater Core. This requires one to pressurize the Cooling System and loosen the heater hose at the HIGHEST POINT and bleed the Air out of the Heater Core. I am not familiar with the Nissan but have encountered this problem numerous times over the years. Most late model vehicles are equipped with Air Bleed devices which must be utilized any time coolant is drained and refilled.

Most all reputable Auto Parts stores sell and/or rent a pump that temporarily replaces the Pressure Cap that may be utilized to pressurize the system for this purpose. If you don't feel capable of performing the bleeding operation take your vehicle to an ASE Certified Mechanic and have it done correctly.

Dec 07, 2009 | Nissan Xterra Cars & Trucks

2 Answers

Car starts poorly during cold mornings. The idle


Sounds like a cold start valve (which is actually an additional injector in the intake to assist in cold starting) If you can get it to your local prts store while the light is on they will read the codes for free and tell you what the car thinks is amiss.

Nov 13, 2009 | 1992 Acura Vigor

1 Answer

Hard starts in the morning even though replaced most parts


Check the power to the cold start injector. (it's only going to have fire for a few sec. after the key is turned on). If the fire is good, replace the cold start injector. This injector is activated for a few seconds when the engen temp is low to add a little fuel lower down in the intake and closer to the pistons.

May 20, 2009 | 1994 GMC Jimmy

1 Answer

Car makes funny noise upon starting on very cold days


Have your power steering belt checked and adjusted, or replaced if worn.

Jan 20, 2009 | 1998 Plymouth Breeze

1 Answer

Battery dies in extremely cold weather


Sounds to me like you have a weak batt. also if you rear lights are sticking on some times that could drain it

Dec 13, 2008 | 2002 Jaguar Vanden Plas

1 Answer

Very Noisy Warmup cycle with my ML1210


put your ear closer to printer to detect source of noise, put all gears out and check each one and reassemple them, I hope you solve your prob.

Dec 28, 2006 | Samsung ML 1210 Laser Printer

Not finding what you are looking for?
Air Tools & Compressors Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Air Tools & Compressors Experts

John Trevino

Level 3 Expert

1388 Answers

Joe Garcia
Joe Garcia

Level 2 Expert

205 Answers

Brad Brown

Level 3 Expert

16147 Answers

Are you an Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...