My electrolux esl 624 dishwasher keeps tripping

you need to remove the bottom plate and clean up any water. it most likely means there is a leak in the gasket around the door and it tripped the flood sensor. the only way to reset it, is to deal with any water and dry it up and then power down and power up the washer.

More importantly I would look for leaks. Bad hoses or possible rubber that dried out and cracked. Maybe someone spilled water and it got on the sensor too. Either way , water is what causes that sensor to activate.

According to your description of the fault, something was blocking drain turbine of main motor. Dishwashers always first start drain water because calibration of water level inside dishwasher (empty). In your case, the main motor is same motor for washing and draining. Runing in one direction means washing, runing to oposite side means draining.
The solution is to open a turbine pump and remove all obstacles and visual check turbine impeller,ceramic seal and plastic sleeve on the motor shaft.

Dado

Good Morning Friend,

I understand that your Electrolux dishwasher, model# ESL4114, keeps tripping your main breaker. This appears to be a UK Electrolux dishwasher. I suggest contacting the manufacturer directly for further assistance. Hope this is helpful.

-Best Regards-
WP

Hi Peter Gumbrell - Often when the dishwasher door does not lock, it is because the of door lock assembly. The door lock or latch may either be faulty or damaged. If I was in your position, I would personally recommend consulting a professional to accurately diagnose the dishwasher to determine the root cause to reduce the risk of unnecessary parts.

red - is active power
black - ground or neutral

I've been dealing w/electrolux for over 2 years on a dishwasher problem. Technician have tried all that they know & the dishes still come out dirtier than when they go in. I've been using it as a drying rack. Kinda exspesive drying rack. Electrolux won't stand behind their product either.They are offering me a 60% discount on a new Elextrolux dishwasher! Are they kidding?

Best off to call a certified repair company such as Sears.

I had a similar problem - seemingly stuck or locked with a solid light showing (in my case on the 65 degree wash). Nothing seemed to unlock it. But when I closed it and went away to think about what to do next - some 5 minutes later - it made its end-of-cycle peeps. It now works fine. All I can think of is that I must have interrupted the previous wash cycle l was using before it had ended, and had left the door ajar. all it needed was the door closing for the cycle to finish. Does that help?

PROGRAM WONT RESPOND MACHINE NOT STARTING

I have trouble with only the top not cleaning properly and have found blockages in the spinning jets at the top, may be worth checking