How do I copy on 4x6 index cards using the bypass on a Kyocera 2550

This means check waste toner container after doing a lot of copies.

All the information for your product can be found here, including documentation, drivers, etc.

http://www.kyoceradocumentsolutions.eu/index/products/product/fs6525mfp.html

Hope this helps, Nik.

Try loading paper in the bypass on the left hand side of the machine.It may be that you are trying to print a document that is a different size to the paper that you have loaded in the copier.

Sounds like you are not using genuine Kyocera toner.
Try using new toner can take a few hundred copies to work through the machine.

first chek dev unit toner? pls insert toner 1087+ 1087+ 130 set dev enter ok then 10 mnt wait and check drum and dp closing time corect sitting or chage edge of dp unit you cleang time smothing wrong?? comng blnk copy

Set toner container. The toner container is not set properly. Set the toner container properly. See page 5-5 of the operation guide.

Replace Waste Toner Box The waste toner box is full. Replace the waste toner box with a new one. See page 5-5 of the operation guide.

If your prints or status page prints normally and the light/faint area is only when making a copy then the mirrors in the optics need to be cleaned. They can get dusty or build up a film on them. You must turn off and unplug the copier then remove the large glass that you place your original on. There are two screws to the left of the large glass if you remove them the piece of plastic that holds the glass in place on the left can be removed. Left the glass off. If you are careful you can grab the center of the mirror base that houses the lamp that comes on when making a copy and slide it slowly to the right. This will allow you enough space to clean the mirrors. Use a clean lint free cloth with a mild glass cleaner (with no amonia). Put everything back to were it was and plug in and turn on the machine and you should be all set.

IF it says downloading program it sounds like it is trying to update the firmware. Did someone stick a compact flash card in the CF card slot. If so removed the CF card and reboot the machine.

Hi, Replace main PCB

HI there try the following.

• Open Internet Explorer
• Type in the address bar the IP address of the scanner (If you do not know this print out a status page)
• Once you have typed in the IP address you will then have the scanner configuration screen on the left you should have passwords section you will be able to change it from there.

Hope this helps you
Thanks J