Err 01 little sister ses

Technical Manual and other suggestions. Professional machines really need professional service as the repair is very specialized, and the dangers of using incorrectly sterilized tools injurious to health.

T echnical Manual

Frank's Hospital Workshop http://www.frankshospitalworkshop.com > Esch...
The SES Little Sister 3 is a portable electrically operated steam autoclave suitable for the sterilization of unwrapped metal instruments and utensils. 4. The ...
47 pages

Watch out for These 7 Common Autoclave Problems

Consolidated Sterilizer Systems https://consteril.com > common-autoclave-problems
1. The sterilizer won't reach the temperature set-point. · The steam generator is need of repair. · There is a clog in the chamber drain (i.e. check the chamber ...

Missing: Sister ‎' Show results with: Sister

They need professional servicing every 12 months according to the manual.
http://www.frankshospitalworkshop.com/equipment/documents/autoclaves/service_manuals/Eschmann%20Little%20Sister%203%20Autoclave%20-%20Service%20manual.pdf

https://www.google.com/search?q=little+sister+ses+2010+autoclave+descaling+instructions

..

That error is a door fault, check the door switch for alignment and proper function

Check the drain pipe that vents steam through resevoir at end of cycle , could be simple debris blockage, or vent valve not opening,play safe autoclaves are like accidents waiting for a place to happen -steam under pressure..

Check the fuses located on both sides of the mains connection in the back of the autoclave. One of them has blown. If both check ok, then check the connection tho the mains. You may have a faulty ground. If you are not comfortable doing this, contact Eschmann at tel:+44 (0)1903 753322
Fax: +44 (0)1903 875789
[email protected]

Here is a link to the technical manual:
http://www.njcautoclaves.com/pdf/LS3-None-Vac-Parts-Explosion.pdf

It doesn't list an error code of 1 just 2-9 so I have no ideal.

Visually check for obstructions on the door seal area. Clean gasket and its mating face. Run Cycle again.

Error 3 is a Door lock error and has nothing to do with the water sensor. Tighten the door down snuggly, but don't over-tighten. If it still doesn't work it may need a door rebuild or switch replacement. Call for service if it doesn't restart.

dear sir
i need catalogue for little sister 2
thanks

do you recommend that the 1st cycle of the day be empty or is it ok with instruments in place?