Dimensions of dishwaher - Kenmore 15529 Built-in Dishwasher

It is likely the door switch is not engaging properly. Check the gasket is set properly and the door is closing when you shut it. Also confirm if it is not on delay start.

I had a similar problem with my Whirlpool dishwaher, and it turned out that my water softener was not working. Once that was resolved, I found that I have to use a rinsing agent in the dishwaher to completely eliminate spots on the cleaned dishes.

Hi,

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...

Dishwasher Spray Arms not Spinning

How to Buy Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

heatman101


jklfryyr

you may have water under the dishwaher ... have any plumbing work done lately?

if the dishwaher overflows or leaks it will trip a float switch under the dishwasher... as long as it is triped it will run the drain pump.. and not let any water into the tub...

the water will have to be removed and the leak stopped before it will run a cycle....

Hope this helps if not let me know more about your problem..

generic reply normly in the center and looks like a plastic grating, but is your drain hose kinked?

Hi charlb1,

I'm Harvey the Master Plumber.

Your problem is: On starting the dishwasher there is no sound at first. After several minutes the alarm beeper starts. Looking inside the machine, the bottom of the dishwaher has several liters of water and the machine is stopped. It is not heating, spraying, rinsing nothing

I'm sorry to say it sounds like you have either a bad control board or a bad motor. I don't recomend these kinds of repairs for the average homeowner. If it's still in warranty, use it. You might consider the Repair Directory for a repairman or if the d/w has a few years on it perhaps it's time to compare repair verses replacement.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber

jet dry cleaner??? im thinknin its also a dishwasher detergent???if so i wouldn 't worry about at all, no way to empty the dispensor, it will dispence on its own over the coarse of a month. but yea so long as its a dishwasher detergent i would not worry about harm to family

Generally, you need only hot water. It is advisable that the drain line be a little lower than used by a washer. Drains usually go into a modified portion of the sink's j bend in the drain. This sits at about 18 inches off the floor. You should fuse your electric line for 20 amps at 120 volts or 15 amps at 240, depending on your location. North American units are at 120.

Hi error code A13 means the soap dispensor on the inside of your dishwaher door is shorting out and will need to be replaced.
This is a fairly quick job and is relativly cheap to do

Some problem. Here I have a Kenmore quietguard that washes the dishes fine but it does not heat up and dry the dishes when it completes. Any idea.