Question about Cobra 19 DX IV CB Radio

1 Answer

Cobra 19 dx lv

Recives good but when goes to talk i'm all broke up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has answered 200 questions.

  • Expert
  • 211 Answers
Re: cobra 19 dx lv

Sounds as though you may have a poor or bad antennas system. I would suggest to check the antenna match ( SWR, Standing Wave Ratio) and if it's good, you might think about a better antenna. Good Luck
NC Electronic
Mills, Wyoming

Posted on Jan 07, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Transmitting and Receiving Signals

Modulation being muffled could be the mic or it could be an adjustment in the unit.

May 21, 2013 | Cobra 19 DX IV CB Radio

1 Answer

Way over modulated on my cobra 19 dx iv

check the frequency,these radios are good for the money,but drift off frequency,try different channels and see if that helps

Mar 10, 2012 | Cobra 19 DX IV CB Radio

1 Answer

I have an older cobra 19 dx the mic cord got pulled out its a 4 pin ther is a purple,red,black with yellow and a bare wire i would like to know wich one goes where?

On the Internet search "Cobra 19 mic wiring" and you'll get lots of hits with wiring instructions for various mics used on that radio. You will need some soldering skill to put it back together. Also use shrink tubing to seal it up afterwords so no unshielded wires appear outside the wire clamp. There are lots of compatible 4-pin Cobra mics at CB shops and truck stop shops.

Feb 19, 2011 | Cobra 19 DX II 40-Channels Base CB Radio

1 Answer

Wanting to put a cobra 19 dx IV cb radio in my truck and i need to know how do i connect the powersource to the fusebox

If I were you, I'd hook the power source directly to the battery. There should be a plug like rubber thing near your brakes. Take that out and run your wire from the cb radio to the battery. This way the truck doesn't have to be turned on to talk. Just make sure that you turn the cb radio off each time you use it or you'll drain the battery.

Sep 15, 2010 | Cobra 19 DX IV CB Radio

1 Answer

Cobra 19 DX IV out of frequency

I would definitely take it back for a re check. If the radio took a good bump perhaps it can cause it to drift off frequency. Turning the channel while holding his mic keyed does nothing but just throws a dead carrier. No value what soever. RF Gain is just to improve his reception by either lowering or raising the sensitivity of the receiver of the radio. Squelch is to silence the hissing sound you hear when no one is talking. Care must be taken to not to adjust too much or you wont hear anybody. It wont help his transmit audio at all. Recommend you get another Radio Check from someone else. He could be pulling your leg saying you don't sound good. Best regards and hope this helps some......................John.

May 27, 2009 | Cobra 19 DX IV CB Radio

1 Answer

My send is fuzzy and hard to understand. I recieve just fine

Perhaps you need to check your SWR? See the following link:

Jul 26, 2007 | Cobra 19 DX IV CB Radio

Not finding what you are looking for?
Cobra 19 DX IV CB Radio Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cobra CB Radios Experts

Level 2 Expert

489 Answers


Level 3 Expert

3018 Answers


Level 2 Expert

204 Answers

Are you a Cobra CB Radio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides